Abstract:Silicon-based materials have become one of the most likely materials to replace graphite anodes of Li-ion batteries due to their ultra-high theoretical specific capacity, safe lithium intercalation potential, and abundant reserves. However, the large volume effect of silicon-based materials during cycling has become a serious obstacle to their commercial application. Silicon-metal composite is one of the potential solutions to alleviate the volume effect of silicon-based anode. Traditional electrodes are prepared by slurry coating method, and the electrodes crack and fall off after many cycles, resulting in capacity loss. In this paper, a cold spraying method combined with ball milling was proposed to prepare silicon-copper composite electrodes to improve the bonding between electrode materials and the cycling stability of the electrodes. Composite powders with different component ratios were first prepared. Then, the micromorphology, bond strength, thermal conductivity, and electrochemical performance of the electrodes prepared by the slurry coating method and the cold spray method were analyzed, respectively. The results show that the Cu 100- x Si x cold sprayed electrodes have higher bond strength and porosity, while the higher porosity of the cold-sprayed electrodes does not promote heat transfer. After the addition of conductive carbon black, the electrodes exhibit better structural stability, cycling performance, capacity retention, and reaction kinetics, with the Cu 80 Si 20 + SP cold prayed electrode exhibiting 600 mAh g −1 after 200 cycles. This work not only successfully prepared a silicon-copper composite anode with excellent performance but also provided a reference for the preparation of other composite electrodes by cold spray combined with ball milling.

Cu5Si–Si/C composites for lithium-ion battery anodes

Preparation and Characterization of High Capacity Si-Cu/C Composites as Anode Materials for Lithium-Ion Battery Anodes

Electrochemical properties of Si-Mn/C as anode materials for lithium ion batteries

Synthesis and electrochemical performance of Si/Cu and Si/Cu/graphite composite anode

SiMn–Graphite composites as anodes for lithium ion batteries

Si@Cu composite anode material prepared by magnetron sputtering for high-capacity lithium-ion batteries

Micro-structured Si@Cu3Si@C Ternary Composite Anodes for High-Performance Li-ion Batteries

Synthesizing copper-doped silicon/carbon composite anode as cost-effective active materials for Li-ion batteries

Improved Lithium Storage Capability of Si Anode by Ball-Milling Produced Graphitic Carbon Sheet and Fe3O4 Nanoparticles

Carbon-coated Si-Cu/graphite Composite As Anode Material for Lithium-ion Batteries

Electrochemical reaction of the SiMn/C composite for anode in lithium ion batteries

Scalable synthesis of a porous structure silicon/carbon composite decorated with copper as an anode for lithium ion batteries

Cu–Al–Si alloy anode material with enhanced electrochemical properties for lithium ion batteries

Cu 3 Si-Modified Silicon Nanoparticles Encapsulated within SiO x and Hollow Carbon for Lithium-Ion Battery Anodes

Cu3Si-Modified Silicon Nanoparticles Encapsulated Within SiOx and Hollow Carbon for Lithium-Ion Battery Anodes

Si, Si/Cu Core in Carbon Shell Composite As Anode Material in Lithium-Ion Batteries

High-performance SiO/C/G Composite Anode for Lithium Ion Batteries

FACILE FABRICATION OF SILICON NANOPARTICLE LITHIUM-ION BATTERY ANODE REINFORCED WITH COPPER NANOPARTICLES

In-Situ Synthesis of Multilayer Carbon Matrix Decorated with Copper Particles: Enhancing the Performance of Si as Anode for Li-Ion Batteries.

Preparation of Si-Based Composite Anode for Li-Ion Batteries by Cold Spraying and Its Electrochemical Performance

A facile in situ synthesis of SiC&Si@CNT composite 3D frameworks as an anode material for lithium-ion batteries.