Centrifuge Modeling of Torsionally Loaded Pile Groups

L. G. Kong,L. M. Zhang

DOI: https://doi.org/10.1061/(asce)1090-0241(2007)133:11(1374)

IF: 3.9

2007-01-01

Journal of Geotechnical and Geoenvironmental Engineering

Abstract:This paper reports a series of centrifuge model tests on torsionally loaded I X 2, 2 X 2, and 3 X 3 pile groups in sand. The objectives of the paper are to investigate: (1) the response of the pile groups subjected to torsion; (2) the way in which the applied torque is transferred in the pile groups; (3) the internal forces mobilized in these torsionally loaded pile groups and their contributions to resist the applied torque; and (4) the influence factors that affect the load transfer, such as soil density and pile-cap connection. In these model tests, the group torsional resistances of the pile groups increased monotonically in the test range of twist angles up to 8 degrees. Both torsional and lateral resistances of the individual piles were simultaneously mobilized to resist the applied torque. The torsional resistances were substantially mobilized at small twist angles, while the lateral resistances kept increasing in the whole range of twist angles. Thus, the contribution of the torsional resistances to the applied torque decreased at large twist angles. The piles at different locations in a pile group could develop not only different horizontal displacements, but also different pile-soil-pile interactions and load-deformation coupling effect, hence, the torsional and lateral resistances of the piles are a function of pile location. The soil density had a more significant effect on the torsional resistances than on the lateral resistances of the group piles.