Abstract:In this study, the tensile impact behavior and damage mechanism of a two-dimensional woven carbon-fiber-reinforced-polymer (CFRP) laminates under different high strain rates are investigated. The damage morphologies are illustrated and studied using meso-macroscale finite element analysis (FEA) and Split Hopkinson bar (SHB) test, FEA results are compared and validated with the SHB test results, and proved to be correct with enough accuracy. The matrix crack first appeared, the tensile stress wave propagated along the interface, which causes shear failure at the interface, which dominated the failure of the specimen and formed adiabatic shear bands inside each ply, the adiabatic shear bands begin to develop in areas with interfacial damage, they are formed after structural damage and propagate in the direction of the interface, accompanied by damage evolution. High strain rate 1400, 1600, and 2400 s −1 impacts tend to lead to direct failure of composite laminates compared to low strain rate 600, and 800 s −1 impacts, the Young's modulus with high strain rate 1400, 1600, and 2400 s −1 are more than twice as much compared to low strain rate 600, and 800 s −1 . The plain-woven CFRP laminates is characterized with strain-rate-hardening effect and strain rate sensitivity, with increase of high strain rate from 600 to 2400 s −1 , the Young's modulus increases from 8.91 to 35.7 GPa, whereas the yield strength increases from 397 to 1298 MPa. The delamination occurs between the plies after crack generation inside the epoxy resin matrix, and begins at a certain strain value after the elastic phase, the micro-cracks propagated along the fiber bundle-matrix interface, thus causing interfacial debonding due to shear stress, these factors result in a strain-rate hardening effect.

An experimental study on the tensile behavior of Kevlar fiber reinforced aluminum laminates at high strain rates

Experimental Study of Mechanical Properties of CFRP under Different Strain Rates and Temperatures

Experimental and Theoretical Study on the Strain Rate and Temperature Dependence of Mechanical Behaviour of Kevlar Fibre

An experimental study on the tensile behavior of a unidirectional carbon fiber reinforced aluminum composite at different strain rates

Tensile properties and constitutive modeling of Kevlar29 fibers: from filaments to bundles

EXPERIMENTAL STUDY ON THE TENSILE MECHANICAL BEHAVIOR OF KEVLAR49 FIBRE BUNDLES UNDER DIFFERENT STRAIN-RATES

Experimental Investigation on Strain Rate Effect of High-Performance Fiber Reinforced Cementitious Composites Subject to Dynamic Direct Tensile Loading

Statistical Analysis on High Strain Rate Tensile Strength of T700 Carbon Fiber

Tensile impact behaviors and damage mechanism of woven carbon fiber-reinforced-polymer laminates considering adiabatic shear band

Statistical Mechanics of Kevlar® KM2® Plus Nanostructure: Deformations and High-Rate Impact

Mechanical Properties of Kevlar® KM2 Single Fiber

Tensile Behavior of Carbon Fiber Bundles at Different Strain Rates

Tensile Behaviour and Strength Distribution of Polyvinyl-Alcohol Fibre at High Strain Rates

Strain rate dependence of 3D printed continuous fiber reinforced composites

A Dynamic Constitutive Model and Simulation of Braided CFRP under High-Speed Tensile Loading

Evaluation of Tensile properties of FRP Composite Laminates under Varying Strain Rates and Temperatures

Evaluation of tensile properties of fiber metal laminates under different strain rates

Research on the upper limit of constant strain rates and dynamic fracture behavior for hybrid woven composite

Dynamic Compressive Response and Failure Behaviour of CFRP Composites at High Strain Rates

Effect of Strain Rate on the Transverse Tension and Compression Behavior of a Unidirectional Non-Crimp Fabric Carbon Fiber/Snap-Cure Epoxy Composite

Effect of strain rate on the in-plane orthotropic constitutive response and failure behaviour of a unidirectional non-crimp fabric composite