Abstract:Beam pumping units are the main production modes in the oilfield oil recovery process. As the power-driven equipment is driven by larger electrical power of the pumping motor, the high energy cost problem is widespread and hard to solve. The motor working efficiency is difficult to accurately match to the complex dynamic loads, as the relationship between the motor driven torque and dynamic loads is hard to master precisely, and the accurate calculation of some important variables cannot be effectively solved by the traditional mechanism modelling method. To solve this problem, in this paper, the dynamic changes of the polished rod loads are considered as the dynamic load changes of the beam pumping units and a serial hybrid model for the motor load torque is studied. Firstly, according to the working principles of the beam pumping units and the mechanism models of the pumping motor, belt pulley-gear box and four-bar linkage mechanism are respectively built. Secondly, for the underground frictions, a rough mechanism model based on the energy conservation equation is built first and then a data-driven soft sensor model is adopted to obtain the dynamic fluid levels instead of an off-line measurement, which uses a C index based on the on-line verification method to prevent the over-fitting in data-driven modelling process. Through the research of this article, a serial hybrid model is proposed to build the dynamic relationship between the pumping motor load torque and the polished rod loads, the underground frictions can be taken as a dynamic variable related to the time and the down-hole dynamic fluid level can be obtained by an on-line calculation. The proposed hybrid modelling method is applied to four normal oil wells, and comparisons between the simulation results and the actual test results verify its effectiveness.

Dynamic coupled model for oil-pumping system and electrical machine matching energy-save simulation

Research on Modeling and Control Strategy of Parallel Hybrid Power System in Excavator

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Modeling and Simulation of Non-Linear Dynamic Process of the Induction Motor System with Fluctuating Potential Loads

Study on Dynamic Performance of EFMC System in Hydraulic Excavator

Simulation Analysis of Energy Saving of Variable Speed Hydraulic Driving System for Cutter Head of Shield Tunneling Machine

Dynamic Characteristics of the Over-Actuated Cutterhead Driving System in Tunnel Machine

Research on Dynamic Characteristics of Oil and Gas Suspension Cylinder

Modeling and Optimization for Submersible Pump Tubular Linear Motor Based on Dynamic Load Analysis

Practical Model for Energy Consumption Analysis of Beam Pumping Motor Systems and Its Energy-Saving Applications

Design and Optimization of Self-Compensation Oil Distributor for Hydraulic Motors

Dynamic analysis of the pump system based on MOC–CFD coupled method

Pump-Based Compensation for Dynamic Improvement of the Electrohydraulic Flow Matching System.

Simulation on Parameter Matching Based on Multi Control Strategies of Oil-hydraulic Hybrid Excavator

Modelling for motor load torque with dynamic load changes of beam pumping units based on a serial hybrid model

Research on Dynamic Modeling and Simulation of Complex Mechanical-Electrical-Hydraulic Coupling System

Numerical Simulation of Overturning Phenomenon of Axial Piston Pump Slipper Pair

A Theoretical Dynamic Model to Study the Vibration Response Characteristics of an Axial Piston Pump

A steady-state and dynamic response model for working characteristics prediction of the electromechanical transmission system including eddy-current magnetic coupler

Dynamic Simulation of a Seawater Plunger Pump

A New Coupled Dynamic Model to Study the Vibration and Lubrication Characteristics of Slipper/Swash-Plate Interface in an Axial Piston Pump