Separation and Determination of Ferulic Acid and Protocatechuic Aldehyde by Sweeping-Micellar Electrokinetic Chromatographic Method

李利军,胡大春,郝学超,吴启涛,李彦青

DOI: https://doi.org/10.3969/j.issn.1004-4957.2010.01.015

2010-01-01

Abstract:A sweeping-micellar electrokinetic chromatographic(sweeping-MEKC) method was used for the simultaneous separation and determination of ferulic acid and protocatechuic aldehyde.Effect of pH,concentration of sodium dodecyl sulfate(SDS) and methanol,injection time,injection voltage,composition and concentration of background electrolyte on separation efficiency were optimized.The result indicated that a best separation of ferulic acid and protocatechuic aldehyde was obtained on an uncoated fused silica capillary column(60 cm×50 μm,effective length 47 cm) by using the background electrolyte containing 140 mmol/L SDS,20 mmol/L NaH2PO4 and 16%(by volume) methanol at pH 2.2 with a constant temperature of 25 ℃ and applied voltage of-20 kV.The detection wavelength was set at 316 nm,sample injection time and injection height were selected to be 100 s and 16 cm,respectively.Under the optimum conditions,the separation of ferulic acid and protocatechuic aldehyde was performed within 19 minutes with relative standard deviation(RSDs) of peak area less than 5%.The calibration curves showed good linearity in the range of 0.67-21.4 mg/L for ferulic acid and 0.72-23 mg/L for protocatechuic aldehyde,with detection limits(S/N=3) of 55.5 μg/L and 34.8 μg/L,respectively.The spiked recoveries were 94%-108% and 91%-106%.Compared with MEKC method,the sweeping-MEKC method showed high separation efficiency,good sensitivity,and was applied in the simultaneous separation and determination of ferulic acid and protocatechuic aldehyde with satisfactory results.