Abstract:A larger (6.1 L) MFC stack made in a scalable configuration was constructed with four anode modules and three (two-sided) cathode modules, and tested at a wastewater treatment plant for performance in terms of chemical oxygen demand (COD) removal and power generation. Domestic wastewater was fed either in parallel (raw wastewater to each individual anode module) or series (sequentially through the chambers), with the flow direction either alternated every one or two days or kept fixed in a single direction over time. The largest impact on performance was the wastewater COD concentration, which greatly impacted power production, but did not affect the percentage of COD removal. With higher COD concentrations (similar to 500 mg L-1) and alternating flow conditions, power generation was primarily limited by the cathode specific area. In alternating flow operation, anode modules connected to two cathodes produced an average maximum power density of 6.0 +/- 0.4 W m(-3), which was 1.9 +/- 0.2 times that obtained for anodes connected to a single cathode. In fixed flow operation, a large subsequent decrease in COD influent concentration greatly reduced power production independent of reactor operation in parallel or serial flow modes. Anode modules connected to two cathodes did not consistently produce more power than the anodes connected to a single cathode, indicating power production became limited by restricted anode performance at low CODs. Cyclic voltammetry and electrochemical impedance spectroscopy data supported restricted anode performance with low COD. These results demonstrate that maintaining power production of MFC stack requires higher influent and effluent COD concentrations. However, overall performance of the MFC in terms of COD removal was not affected by operational modes. (C) 2016 Elsevier Ltd. All rights reserved.

Improved Performance of Air-Cathode Single-Chamber Microbial Fuel Cell for Wastewater Treatment Using Microfiltration Membranes and Multiple Sludge Inoculation

Improved Performance of Microbial Fuel Cells Enriched with Natural Microbial Inocula and Treated by Electrical Current

Development of a Novel Membrane-less Microbial Fuel Cell (ML-MFC) with a Sandwiched Nitrifying Chamber for Efficient Wastewater Treatment

Performance Improvement of MFCs by Treatment of Carbon Cloth Anode with Ultrasonic or Spent Anolyte

Microbial Fuel Cell Using Surplus Sludge Treated by Different Ways

A Novel Filtration Composite Anode Configuration of Microbial Fuel Cell for Efficient Wastewater Treatment and Enhanced Power Generation

Performance and Application of Microbial Fuel Cells with Sodium Alginate/agar/activated Carbon Composite As Efficient Biocompatible Anode

Integration of Microbial Fuel Cell with Independent Membrane Cathode Bioreactor for Power Generation, Membrane Fouling Mitigation and Wastewater Treatment

Enhanced Power Density and Decolorization of Air-cathode Single-chamber Microbial Fuel Cells with Microfiltration Membranes

Pre-acclimation of a wastewater inoculum to cellulose in an aqueous-cathode MEC improves power generation in air-cathode MFCs.

A Microbial Fuel Cell Producing Electricity Directly from Municipal Wastewater Treatment

Microbial fuel cells with an integrated spacer and separate anode and cathode modules

Treatment of domestic sewage with anoxic/oxic membrane-less microbial fuel cell with intermittent aeration

Power Generation in Dual Chamber Microbial Fuel Cells Using Dynamic Membranes As Separators

Multi-anode enhanced the bioelectricity generation in air-cathode microbial fuel cells towards energy self-sustaining wastewater treatment

Assessment of an Anaerobic Membrane Bio-Electrochemical Reactor (anmber) for Wastewater Treatment and Energy Recovery

Microbial Fuel Cells: the Effects of Configurations, Electrolyte Solutions, and Electrode Materials on Power Generation

The performance of microbial fuel cell with sodium alginate and super activated carbon composite gel modified anode

In-situ integration of microbial fuel cell with hollow-fiber membrane bioreactor for wastewater treatment and membrane fouling mitigation.

Performance of a Combined System of Microbial Fuel Cell and Membrane Bioreactor: Wastewater Treatment, Sludge Reduction, Energy Recovery and Membrane Fouling.

The Effect of Fl Ow Modes and Electrode Combinations on the Performance of a Multiple Module Microbial Fuel Cell Installed at Wastewater Treatment Plant