Abstract:In order to directly observe the conversion between guided-wave modes and leaky-wave modes in a periodic structure, quadrilateral periodic metal diaphragms arranged in two ways on metal surfaces were analyzed. In the first scheme, each unit cell in the periodic structure contains a metal diaphragm, of which the dispersion characteristics of periodic structures were analyzed by the finite element method. The results of the numerical simulation show that by adjusting lattice constants of periodic structures and geometrical parameters of metal diaphragms, the transmission bandwidth of the present 1-D periodic metal diaphragm structures could be limited to X-band, where the transmission characteristics are easy to be measured. In the second scheme, a pair of mirror-symmetric and staggered quadrilateral metal diaphragms is introduced into a unit cell. It can be found in the theoretical calculation that a new dispersion curve, which passes through the light line in a high frequency range, can be exhibited. The propagation constants of dispersion curves become complex numbers and provide highly directional electromagnetic radiation that scans as the frequency changes. After the relative positions of the two metal diaphragms were properly adjusted, the frequency range of the forbidden band gap between two dispersion curves can be minimized, so as to increase the transmission bandwidth of the 1-D periodic metal structures. The experimentally measured results show that the dispersion curves of the two periodic structures were highly consistent with the theoretical results. The narrowing of the band gap could be verified by measuring the $S$ -parameters. The near-field measurement of the periodic metal structures can demonstrate the conversion between the guided-wave modes and the leaky-wave modes, and the far-field measurement can show the frequency dependence of beam elevation. We expect that these artificial material structures could be widely used for designing new microwave and terahertz band devices.

Observation of Large Positive and Negative Lateral Shifts of a Reflected Beam from Symmetrical Metal-Cladding Waveguides.

Theoretical Large Positive and Negative Lateral Beam Shift of the Metal Cladding Waveguide in the Mid-Infrared Region.

Large Negative and Positive Lateral Shift on Reflection from a Left-Handed Prism Coated with a Weakly Absorbing Dielectric Film

Large Positive and Negative Lateral Beam Displacement in a Guided-Mode Resonant Filter

Simultaneously Large and Opposite Lateral Beam Shifts for TE and TM Modes on a Double Metal-Cladding Slab

Large Negative Lateral Shifts from the Kretschmann–Raether Configuration with Left-Handed Materials

Rigorous analysis of the spatial dispersion effect in multilayer thin-film coatings.

Large Lateral Shift Near Pseudo-Brewster Angle on Reflection from a Weakly Absorbing Double Negative Medium.

Physical origin of large positive and negative lateral optical beam shifts in prism–waveguide coupling system

Large positive and negative lateral optical beam shift in prism-waveguide coupling system.

Negative and Positive Lateral Shift of a Light Beam Reflected from a Grounded Slab.

A Direct Near-Field Observation of Conversion Between Waveguide Modes and Leaky Modes in Periodic Metal Structures

Large negative lateral shifts due to negative refraction

Negative Goos-Hanchen Effect in Thin-Film Fabry-Perot Filter

Structure-Induced Hyperbolic Dispersion in Waveguides

The Goos-Hanchen Shift on the Surface of Uniaxially Anisotropic Left-Handed Materials

Nonreciprocal Normal-Incidence Lateral Shift for Transmitted Wave Beams Through the Magnetic Photonic Crystal Slab

Positive and Negative Spatial Dispersion Effects of Optical Thin Films

Lateral Displacement of an Electromagnetic Beam Reflected from A Grounded Indefinite Uniaxial Slab

Large negative Goos-Hänchen shift from a weakly absorbing dielectric slab.

1.5 Mm Light Beam Shift Arising from 14 Pm Variation of Wavelength