Abstract:For the interior anchorage zone in post-tensioned concrete structure, International Federation for Presterssing (FIP) proposed a design method based on the theory of Strut-and-Tie Model (STM) (called FIP-STM in the following context). However, the condition of FIP-STM is that the dimension ratio of anchor, b/h , is equal to 1/9. In this paper, the stress distribution in interior anchorage zone was analyzed via using Finite Element Method (FEM) at first. The relationship between ratio of internal force over post-tensioned load ( F/P ) and dimension ratio ( b/h ) ( F/P-b/h curve) was obtained. FEM results show that in case of b/h <1/9, the interior anchorage zone can be simplified to the core region, in which b/h is equal to 1/9 and FIP-STM is still applicable. However, in case of b/h >1/9, the amount of non-prestressed rebar designed in interior anchorage zone by use of FIP-STM is more than that required, and in some cases it is difficult to allocate non-prestressed rebar in the crowded space. Based on the results of stress analysis, a modified approach for FIP-STM was presented, which can be applied for any dimension ratio. With the proposed modification on FIP-STM, the non-prestressed rebar can be reasonably allocated in the narrow space of interior anchorage zone via modifying the internal forces and geometry of FIP-STM. The analytical result shows that for interior anchorage zone about 30% of non-prestressed rebar can be reduced via using the proposed method compared with that using FIP-STM if b/h is equal to 3/10.

MODIFICATION OF FIP STRUT-AND-TIE MODEL FOR DESIGN OF INTERIOR ANCHORAGE ZONES OF POST-TENSIONED CONCRETE STRUCTURES

A design approach for the interior anchorage zone of post-tensioned concrete structure

Application of strut-and-tie model for design of interior anchorage zone in post-tensioned concrete structure

Strut-And-Tie Model Research On Bridge Column-Pile-Footing

Investigation and Improvement of Strut-and-tie Model for Design of End Anchorage Zone in Post-Tensioned Concrete Structure

Experimental Evaluation of Strut-and-Tie Model of Anchorage Zone in Posttensioned Concrete Structures

A UNIFIED ANALYSIS METHOD FOR DISTORTIONAL AND GLOBAL BUCKLING OF Z-PURLINS IN FLEXURE

Design Approach of Stiffeners in Extended End Plate Connections and Finite Element Analysis

Approach for Analyzing the Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges with Stiffening Girder

FINITE ELEMENT ANALYSIS OF STIFFENED T-STUB CONNECTIONS

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

Strut-and-tie Model Method for Design of Reinforced Concrete Structures:Part Ⅰ Model Development

Assessment of Internal Forces for Intermediate Anchorage Zone of Post-Tensioned Concrete Structure

Internal Force Calculation and Stability Analysis of the Slope Reinforced by Pre-Stressed Anchor Cables and Frame Beams

Strut-and-tie model for FRP effectiveness in shear strengthening of RC deep beams

Research on Optimum Design of Retaining Piles Structure with Interior Bracing

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Numerical Analysis and Punching Shear Fracture Based Design of Longitudinal Plate to Concrete-Filled CHS Connections

FINITE ELEMENT ANALYSIS ON CONCRETE-ENCASED CFST COLUMN TO REINFORCED CONCRETE BEAM JOINTS

Strut-and-tie Model Method for Design of Reinforced Concrete Structures-Part Ⅱ:design

Internal Force Transfer Mechanism and Bearing Capacity of Vertical Stiffener Joints in CFDST Structures