Abstract:This paper presents a combined experimental and numerical investigation on aerodynamic load reduction through steady blowing on the suction surface of a swept wing. In the experiment, a swept wing with an array of jet exit holes near the wing tip was studied in a low-speed wind tunnel. Numerical studies based on solving the Reynolds-averaged Navier-Stokes equations provide further insight into aerodynamic load and bending moment reduction and the associated flow physics caused by the surface jets with various jet parameters, including blowing direction, blowing strength and jet velocity distribution. It is found that the upstream blowing causes a much larger reduction in both lift and bending moment than that caused by the normal blowing. Both the experiment and numerical simulations confirm that the aerodynamic load reduction increases as the jet momentum increases. It is also found that the linear jet velocity distribution, with the lowest blowing velocity at the outer end (y/b=0.98) of jets region and the highest blowing velocity at the inner end (y/b=0.755), achieves the maximum aerodynamic load reduction among the six different distributions studied. In addition, three key flow mechanisms associated with aerodynamic load reduction are identified, including the pressure rise on the suction surface caused by the flow separation, the wingspan shortening effect caused by the large drop in lift in the tip region of a three-dimensional swept wing as well as the jet reaction force.

Numerical Simulation of Externally Blown Flap Effect with Different Turbofan Positions

NUMERICAL SIMULATION OF A THIN PLATE IMPACTED BY BLADE PROJECTILE

Numerical Simulation of 2D Airfoil Lift Enhancement with Flaps

Numerical Simulation on Effects of Flight Parameters on Internal Flow of Jet Vector Nozzle

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Numerical simulation of flow in the nozzle of turbo-expender

Numerical Study on Nozzle Exit Flow Angle for Radial Turbine

Numerical Research on Effects of Turbine Outlet Flow Angle on Aerodynamic Performance of Wind-Ejector of Low-Speed Wind Turbine

A combined experimental and numerical study on aerodynamic load reduction for a swept wing by using jets

Numeral Simulation of Turbocharged End in Medium-pressure Cryogenic Turboexpander

Numerical Study on the Effect of Jet Slot Height on Flow and Heat Transfer of Swirl Cooling in Leading Edge Model for Gas Turbine Blade

Influence of Flap Parameters on the Aerodynamic Performance of a Wind-Turbine Airfoil

Research of Comprehensive Modeling of Two-Dimensional Vector Nozzle/Actuator Load/Turbofan Engine

Numerical simulation on the effect of jet nozzle position on impingement cooling of gas turbine blade leading edge

Numerical Investigation of Leading Edge Flap on Cranked Arrow Wing

Numerical Simulation for Transonic Flows at High Incidence Around a Complete Fighter with Two-Equation K-G Model

Numerical Study on Configuration and Aerodynamic Characteristics of Triangular Flaps for Wind Turbine Blades

Influence of Trailing Edge Flap on Wind Turbine Blade Using Three-Dimensional Computational Fluid Dynamics Method

Numerical Simulation of 2D Jet-to-Crossflow Heat Transfer with Different Turbulence Models

Simulation Research of Effects of Turblence Model on the Aerody namic Performance and Flow Field Structure in High-press Ratio Centrifugal Compressor