Abstract:Large beam-anode layer ion source can produce high-density ions, and has been widely used in plasma cleaning and assisted deposition. However, when increasing the ion-beams, arcing always occurs inside the ion source and serious etching will take place on the cathode which results in sample pollution especially in long-time cleaning. This work proposes two designed structures, called magnetic shields surrounding the anode and sputtering shields on the top of the inner and outer cathodes, respectively. The influence of the designed structure on the electromagnetic field and the plasma properties of the ion source are studied by a self-established simulation techniques based on the particle-in-cell/Monte Carlo collision method and test particle Monte Carlo method. The results show that the magnetic shields surrounding the anode cut off the magnetic induction line between the cathode and anode, which eliminates the arcing condition in the ion source. The sputtering shields for the cathodes use alumina ceramics because of the extremely low sputtering yield and high insulation performance. Therefore, the sputtering shields can not only resist the ion sputtering, but also shield the electric field on the outer surface of the cathode. As a result, the plasma discharge region is compressed towards the anode and away from the cathode simultaneously, which provides a stronger electric field force directed to the output region for Ar+ ions, also resulting in a suppressed cathode etching behavior but an improved Ar+ ion output efficiency. The optimized calculation shows that the best distance from the sputtering shields to the cathode surface is 9 mm. The discharge experiments reveal that the modified ion source can eliminate the inside arcing and provide a clean and strong ion beam with a high efficiency. At the same discharge current, the output efficiency of the modified ion source is 36% higher than that of the original ion source. When used in the plasma cleaning, the glass substrate remains transparent and keeps the original element composition ratio. The detected Fe content, comes from the cathode sputtering, is only 0.03% after the plasma cleaning for 1 h, which is 2 orders of magnitude smaller than that cleaned by the original ion source. The Fe content of the modified ion source is about 0.6% of the original ion source, which is in good agreement with the result of simulation optimization.

Negative Corona Discharge Ion Source under Ambient Conditions with Mini Line-cylinder Electrodes

Ambient negative corona discharge ion source with small line-cylinder electrodes

Novel Chemical Ion Source for a High-Field Asymmetric Waveform I Mobility Spectrometer Used under Ambient Conditions

Comparison of Styrene Removal in Air by Positive and Negative DC Corona Discharges

A SMALL-SIZE ARC-DISCHARGE ION-SOURCE

Development of Volume Produced Negative Ion Source using a CCRF Discharge

Development of a Dielectric Barrier Discharge Ion Source for Ambient Mass Spectrometry

An Analytical Method for DC Negative Corona Discharge in a Wire-Cylinder Device at High Temperatures

Nanoscale discharge electrode for minimizing ozone emission from indoor corona devices.

Experimental Investigation of Ion Beam Extraction in Filament-Driven Negative-Carbon-Ion Sources With Various Geometrical Configurations for Accelerator Mass Spectrometry

Factors Influencing the Electron Yield of Needle-Ring Pulsed Corona Discharge Electron Source for Negative Ion Mobility Spectrometer

Development of a negative helium ion source with non-metallic charge exchange

A Simple and Demountable Capillary Microflow Nebulizer with A Tapered Tip for Inductively Coupled Plasma Mass Spectrometry

Modified Miniature Metal Vapor Vacuum Arc Source for the Shanghai Electron Beam Ion Trap

Development and Application of Self-aspiration Hollow Needle Corona Discharge Ionization Source

A Low-Cost Demountable Direct Injection High-Efficiency Nebulizer for Inductively Coupled Plasma Mass Spectrometry

Ionization processes of negative corona discharge. Part 2. Theory. Comparison with experiment

Study and Elimination of the Cathode Etching on Large Beam-Anode Layer Ion Source

A gapless micro-dielectric-barrier-discharge ion source for analytical applications

Realization of Atmospheric Pressure Glow Discharge Ion Source in Small Gap with Precise Electrode Structure

Study on stray electrons ejecting from a long-pulse negative ion source for fusion