Abstract:Using granulated blast furnace slag (GGBS) as the volcanic ash material and fly ash (FA) as the supplementary material, the study was conducted to investigate the mix proportions of an alkali-activated solid waste cementitious material under the stimulating effect of alkali activator carbide slag (CS). This type of cementitious material could serve as a substitute for a portion of cement usage, contributing to resource conservation and mitigating environmental pollution caused by solid waste. This facilitates green and sustainable development. Firstly, an analysis of three raw materials was conducted, and the mix proportions were designed with reference to the CaO-Al 2 O 3 -SiO 2 system of Portland cement. Then 28 groups of specimens were prepared based on the designed mix proportions. The flowability and setting time of each group of specimens were tested. It was observed that an increase in the amount of CS and a decrease in the amount of GGBS resulted in decreased flowability and earlier setting times of the specimens. Additionally, FA exhibited a retarding effect on setting time. Compressive strength tests were conducted on these specimens, revealing that the optimal CS content ranged between 20 % and 40 %. Overall, FA had minimal impact on compressive strength, but it contributed to increased compressive strength in the specimens at later ages. Subsequently, microscopic characterization of the hydration products was performed using X-ray Diffraction (XRD), Fourier Transform Infrared (FTIR), Differential Thermal Analysis (DTA), Scanning Electron Microscope (SEM), and Energy Dispersive Spectrometer (EDS). The hydration products were identified as predominantly composed of calcium silicate hydrate. The quality and defects in the microstructure of gel products from various specimen formulations were compared to elucidate differences in macroscopic performance. Finally, the hydration process mechanism diagram of alkali-activated materials was presented to illustrate the stimulation and formation of gel products, primarily composed of C-S-H. This diagram revealed the principles behind the action of alkali-activated cementitious materials. The proposed design and testing methodology for the GGBS-FA-CS system in this study had certain reference significance for research in the direction of alkali-activated solid waste cementitious materials.

Preparation of Cementitious Material Based on Alkali-GGBS-Manganese Alloy Slag System

Preparation and Performance Study of Manganese Slag-Based Grouting Cementing Material

Study on the Alkali–Sulfur Co-Activation and Mechanical Properties of Low-Carbon Cementitious Composite Materials Based on Electrolytic Manganese Residue, Carbide Slag, and Granulated Blast-Furnace Slag

Synergistic Effects of Steel Slag and Wet Grinding on Ambient Cured Ground Granulated Blast Furnace Slag Activated by Sodium Sulfate

A Low-Carbon Cement Based on Silicomanganese Slag and Granulated Blast Furnace Slag: Hydration Process, Microstructure, Mechanical Properties and Leaching Risks

Mechanical properties and environmental characteristics of the synergistic preparation of cementitious materials using electrolytic manganese residue, steel slag, and blast furnace slag

Effect of Solid Sodium Silicate on Workability, Hydration and Strength of Alkali-Activated GGBS/Fly Ash Paste

Microstructures and properties of alkali-activated slags with composite activator: Effects of Na2O equivalents

Study on the preparation, performance, and mechanism for solid waste cementitious materials

Utilization of Copper–Molybdenum Tailings to Enhance the Compressive Strength of Alkali-Activated Slag-Fly Ash System

Effect of Organic Alkali on Compressive Strength and Hydration of Wet-Grinded Granulated Blast-Furnace Slag Containing Portland Cement

Mechanical Properties and Microstructure Evolution of Alkali-Activated GGBS-fly Ash-Steel Slag Ternary Cements

Alkali-activated Slag Muck Concrete

Durability of Concrete Made with Manganese Slag As Supplementary Cementitious Materials

Comparison of Mechanical Properties and Microstructure of GGBS-based Cementitious Materials Activated by Different Combined Alkaline Wastes

Alkali-activated slag supplemented with waste glass powder: Laboratory characterization, thermodynamic modelling and sustainability analysis

Preparation of electrolytic manganese residue-ground granulated blastfurnace slag cement

The Use of Slag and Red Mud for the Synthesis of a Slag-Based Cementitious Material

Utilization of carbide slag-granulated blast furnace slag system by wet grinding as low carbon cementitious materials

Effect of carbide slag and steel slag as alkali activators on the key properties of carbide slag-steel slag-slag-phosphogypsum composite cementitious materials

Study on the leaching toxicity and performance of manganese slag-based cementitious materials