Abstract:Carbon nanotubes (CNTs) are considered an advanced form of carbon. They have superior characteristics in terms of mechanical and thermal properties compared to other available fibers and can be used in various applications, such as supercapacitors, sensors, and artificial muscles. The properties of single-walled carbon nanotubes (SWNTs) are significantly affected by geometric parameters such as chirality and aspect ratio, and testing conditions such as temperature and strain rate. In this study, the effects of geometric parameters and temperature on the mechanical properties of SWNTs were studied by molecular dynamics (MD) simulations using the Large-scaled Atomic/Molecular Massively Parallel Simulator (LAMMPS). Based on the second-generation reactive empirical bond order (REBO) potential, SWNTs of different diameters were tested in tension and compression under different strain rates and temperatures to understand their effects on the mechanical behavior of SWNTs. It was observed that the Young’s modulus and the tensile strength decreases with increasing SWNT tube diameter. As the chiral angle increases, the tensile strength increases, while the Young’s modulus decreases. The simulations were repeated at different temperatures of 300 K, 900 K, 1500 K, 2100 K and different strain rates of 1 × 10−3/ps, 0.75 × 10−3/ps, 0.5 × 10−3/ps, and 0.25 × 10−3/ps to investigate the effects of temperature and strain rate, respectively. The results show that the ultimate tensile strength of SWNTs increases with increasing strain rate. It is also seen that when SWNTs were stretched at higher temperatures, they failed at lower stresses and strains. The compressive behavior results indicate that SWNTs tend to buckle under lower stresses and strains than those under tensile stress. The simulation results were validated by and consistent with previous studies. The presented approach can be applied to investigate the properties of other advanced materials.

Investigation of temperature effect on the mechanical properties of single-walled carbon nanotubes

Coupled Thermomechanics Of Single-Wall Carbon Nanotubes

Influence of temperature change on column buckling of multiwalled carbon nanotubes

Thermal Effect on Transverse Vibrations of Double-Walled Carbon Nanotubes

Molecular Dynamics Simulations of Effects of Geometric Parameters and Temperature on Mechanical Properties of Single-Walled Carbon Nanotubes

Effect of Temperature on Elastic Properties of Single-Walled Carbon Nanotubes

Investigation of the thermo-mechanical properties of single-walled carbon nanotubes based on the temperature-related higher order Cauchy-Born rule

Dynamic Elastic Modulus of Single-Walled Carbon Nanotubes in Different Thermal Environments

Effects of Strain Rates and Temperatures on the Mechanical Properties of Multi-Walled Carbon Nanotubes

Temperature-Dependent Elastic Properties of Single-Walled Carbon Nanotubes: Prediction from Molecular Dynamics Simulation

Molecular Structure Based Study on the Elastic Properties of Carbon Nanotubes in a Thermal Environment

Molecular dynamics simulation of thermal conductivity of single-wall carbon nanotubes with different structures

Buckling and postbuckling analysis of single-walled carbon nanotubes in thermal environments via molecular dynamics simulation

Molecular Dynamics Study on the Effect of Temperature on the Tensile Properties of Single-Walled Carbon Nanotubes with a Ni-Coating

Tuning Structural and Thermal Conductivity of Carbon Nanotubes under Strain Effects

Effects of Topological Parameters on Thermal Properties of Carbon Nanotubes via Molecular Dynamics Simulation

Prediction of Thermal Expansion Properties of Carbon Nanotubes Using Molecular Dynamics Simulations

Strain controlled thermomutability of single-walled carbon nanotubes.

Molecular dynamics simulation studies of mechanical properties of different carbon nanotube systems

Higher Order Cauchy-Born Rule Based Study of Chiral Single-Walled Carbon Nanotubes

Effects of temperature on mechanical properties of carbon nanotube bundles：molecular dynamics simulation