Abstract:Multiplications have been commonly conducted in quantized CNNs, filters, and reconfigurable cores, and so on, which are widely deployed in mobile and embedded applications. Most multipliers are designed to perform multiplications with symmetric bit-widths, i.e., n - by n -bit multiplication. Such features would cause extra area overhead and performance loss when m - by n -bit multiplications ( m > n ) are deployed in the same hardware design, resulting in inefficient multiplication operations. It is highly desired and challenging to propose a reconfigurable multiplier design to accommodate operands with both symmetric and asymmetric bit-widths. In this work, we propose a reconfigurable approximate multiplier to support multiplications at various precisions, i.e., bit-widths. Unlike prior works of approximate adders assuming a uniform weight distribution with bit-wise independence, scenarios like a quantized CNN may have a centralized weight distribution and hence follow a Gaussian-like distribution with correlated adjacent bits. Thus, a new block-based approximate adder is also proposed as part of the multiplier to ensure energy-efficient operation with an awareness of the bit-wise correlation. Our experimental results show that the proposed approximate adder significantly reduces the error rate by 76% to 98% over a state-of-the-art approximate adder for Gaussian-like distribution scenarios. Evaluation results show that the proposed multiplier is 19% faster and 22% more power saving than a Xilinx multiplier IP at the same bit precision and achieves a 23.94-dB peak signal-to-noise ratio, which is comparable to the accurate one of 24.10 dB when deployed in a Gaussian filter for image processing tasks.

A VLSI Architecture for a Run-time Multi-precision Reconfigurable Booth Multiplier.

A Reconfigurable Multiplier for Signed Multiplications with Asymmetric Bit-Widths.

A Low Latency High Throughput Multiply-accumulator Unit for Float Point and Integer

A Reconfigurable Approximate Multiplier for Quantized CNN Applications.

Booth Multiplier Design Using Modified Square Root Carry-Select-Adder

A Design and Implementation of Radix-4 Based Fast Multiplier on FPGA

Implementation of Booth Multiplier Algorithm using Radix-4 in FPGA

A novel vector/SIMD multiply-accumulate unit based on reconfigurable booth array

Configurable Blocks for Multi-precision Multiplication

Design and Implementation of Radix 8 Booth Encoding Multiplier for Low Area and High-Speed Applications

Architecture Optimization of Word-length Booth Multiplier

VHDL implementation of 16x16 multiplier using pipelined 16x8 modified Radix-4 booth multiplier

Design of efficient binary multiplier architecture using hybrid compressor with FPGA implementation

A modular technique of Booth encoding and Vedic multiplier for low-area and high-speed applications

Asic Implementation of 12-Bit Radix-8 Booth Multiplier

Implementation and Comparison of Radix-8 Booth Multiplier by using 32-bit Parallel prefix adders for High Speed Arithmetic Applications

On the Systematic Creation of Faithfully Rounded Commutative Truncated Booth Multipliers

A Multiplier Structure Based on A Novel Real-Time Csd Recoding

A 64X64-Bit Modified Booth Multiplier Utilizing Multiplexer-Select Booth Encoder

Multiplier Design Addressing Area-Delay Trade-offs by using DSP and Logic resources on FPGAs