Abstract:This research aims at increasing the utilization of platinum-ruthenium alloy (Pt-Ru) catalysts and thus lowering the catalyst loading in anodes for methanol electrooxidation. The direct methanol fuel cell’s (DMFC) anodic catalysts, Pt-Ru/C, were prepared by chemical reduction with a reducing agent added in two kinds of solutions under different circumstances. The reducing agent was added in hot solution with the protection of inert gases or just air, and in cold solution with inert gases. The catalysts were treated at different temperatures. Their performance was tested by cyclic voltammetry and potentiostatic polarization by utilizing their inherent powder microelectrode in 0.5 mol/L CH3OH and 0.5 mol/LH2SO4 solution. The structures and micro-surface images of the catalysts were determined and observed by X-ray diffraction and transmission electron microscopy, respectively. The catalyst prepared in inert gases showed a better catalytic performance for methanol electrooxidation than that prepared in air. It resulted in a more homogeneous distribution of the Pt-Ru alloy in carbon. Its size is small, only about 4.5 nm. The catalytic performance is affected by the order of the reducing agent added. The performance of the catalyst prepared by adding the reductant at constant temperature of the solution is better than that prepared by adding it in the solution at 0°C and then heating it up to the reducing temperature. The structure of the catalyst was modified, and there was an increase in the conversion of ruthenium into the alloyed state and an increase in particle size with the ascension of heat treatment temperature. In addition, the stability of the catalyst was improved after heat treatment.

Research Progress in Anodic Catalyst of Direct Methanol Fuel Cell

Research Progress of Anode Catalysts for Direct Methanol Fuel Cell

Highly Active Nanoporous Pt-based Alloy As Anode and Cathode Catalyst for Direct Methanol Fuel Cells

Recent Progress in Anode Catalysts of Direct Methanol Fuel Cells

A review on Pt-based anodic catalysts in direct methanol fuel cells

Research Progress on Anode Catalyst for Direct Ethanol Fuel Cell

Anode Catalysts and Cathode Catalysts of Direct Methanol Fuel Cells

The research progress in anode non-platinum electrocatalysts of direct methanol fuel cell

Progress in Anode Catalysts and Preparation Techniques for Direct Methanol Fuel Cells

Progress in Research on Cathodic Catalysts for Direct Methanol Fuel Cells

Advances in Multimetallic Anodic Catalysts for Direct Methanol Fuel Cells(dmfcs)

Recent advances in catalysts for direct methanol fuel cells

Research and Development of Electrocatalysts Used in DMFC

Research Progress of Synergistic Effect of Metal Oxides on Pt-based Catalysts

Research Progress of Carbon Monoxide Tolerant Catalysts for Direct Methanol Fuel Cell

Research Progress on the Direct Dimethyl Ether Fuel Cell

Preparation and Influence of Performance of Anodic Catalysts for Direct Methanol Fuel Cell

Progress in Alkaline Direct Methanol Fuel Cell Research

Some Factors Affecting the Performance of Anodic Catalysts for Direct Methanol Fuel Cell

Composite Anode Catalyst Layer for Direct Methanol Fuel Cell