Abstract:The winding segmented permanent magnet linear synchronous motor has restrictions on the last absolute position acquisition when the power goes from off to on, and the traditional absolute position acquisition systems depend on complex battery and calibration systems. Therefore, a true absolute magnetic encoder based on the Vernier principle with error rejection and decoding technology is studied in this paper. First, the output signal of the magnetic encoder with noise was subjected to the adaptive ellipse parameter correction algorithm with recursive least squares (RLS), and the source output signal predicted and reconstructed. Furthermore, the RLS was optimized by the speed weighting factor and the forgetting factor to reduce the computational pressure and the iterative process. Second, one improved double second-order generalized integrator(DSOGI) decoding technology was investigated by extracting and separating the symmetric-positive sequence components in the unbalanced signal, and, using the phase-locked loop technique for tracking calculation, accurate speed and angle obtained. The adaptive ellipse parameter fitting algorithm effectively reduced the problem of overshoot and steady-state error of the DSOGI, which provides a practical and theoretical basis for the future application of the magnetic encoder. This trajectory arrangement not only avoids the influence of accumulated error on the accuracy of encoder, but it also solves the contradiction between high resolution and small volume, and the advantages over the special decoding chip IC-Haus were also verified by comprehensive experimental results.

Technology of Position Servo Magnetic Encoder Based on Industrial Robot

Research on Position Sensor Magnetic Encoder Based on the Elevator Door Machine Servo System

Research on automatic control and servo control technology of industrial robots for high-precision assembly requirements

A Fast Integral Sliding Mode Controller with an Extended State Observer for Position Control of Permanent Magnet Synchronous Motor Servo Systems

An Improved Method to Estimate Initial Rotor Position for Surface-Mounted Permanent Magnet Synchronous Motors

Development of Novel Magnetic Encoder and Vector Control Method for Servo Control of High-Speed Motor

The Study of an Electromechanical Actuator with a Resolver As the Position Sensor

Absolute Position Acquisition for Linear Synchronous Motor with Passive Mover

High-precision magnetic encoder module design based on real-time error compensation algorithm

High Precision Control System Design and Implementation of Outer-Rotor Permanent Magnet Motor with Dual Magnetic Sensors

Magnetic Rotary Encoder and Its Application in PMSM

Vector Control of High Speed PMSM Based on Single-Pole Magnetic Encoder

A MC56F8357 Based Permanent Magnet Synchronous Motor (PMSM) Servo System

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Research On Rotating Encoder Zero-Position Location Based On Missile Steering Gear

High Precise Position Control Of A Novel Electromagnetic Actuator Using Sensorless Detection

Study of Rotor Position Detection Method for Linear Synchronous Motor

Review of Precise Position Estimation Method of PMSM with Low-Resolution Position Sensor

Rotor Position Estimation Approaches for Sensorless Control of Permanent Magnet Traction Motor in Electric Vehicles: A Review

An Integrated PMSM Servo System Based on Embedded Position Detection

Recent Patents on Magnetic Encoder and Its Use in Rotating Mechanism