Abstract:Obtaining high recovery in copper flotation plants has been always under investigation in recent years. Misreported copper into tailing dramatically declines copper recovery. This study aims to find the possible reasons of copper loss to tailing and present the methods to improve the performance of the Sarcheshmeh copper plant flotation circuit. This work was performed in two phases. In the first stage, two surveys were carried out in an industrial plant for evaluation of floatability of two different types of copper ore (sulfide and mixed copper ores comprising sulfide and oxide minerals) and investigation of misreported copper into tailing. In the second stage, influence of particle size distribution in different levels, the collector (Z11 + R407), and sulfidisation agent (NaHS) dosages were investigated on the floatability of mixed copper ore, and possible improvement of copper recovery ores was evaluated by a series of batch flotation experiments. Almost 95% of overall copper loss in final tailing took place in the rougher circuit. The overall recovery of mixed copper ores was obtained 8% less than the other survey. It was found that an important factor of recovery reduction was due to increasing oxide copper proportion in rougher feed. Results of size-by-size recovery analysis showed that the highest sulfide copper loss occurred in coarse particles (>74 µm) and the highest oxide copper loss happened in fine particles (<9 µm). From batch flotation experiments, it was found that the ultimate recovery increased to a certain value with increasing the collector dosage (50 g/t) and thereafter reduced. Increasing the NaHS dosage to 800 g/t resulted in 4.5% increase in recovery from 79.3% to 83.8% with a significant increase in grade. It is observed that size reduction of coarse particles (>74 μm) of rougher tailing and then their flotation have significant effect on increasing overall recovery from 79.3% to 82.2%. Experimental studies showed that the use of the proposed methods with considering the optimized conditions in the plant can be led to an increase in copper recovery from 79% to 87% without any decrease in grade.

Study on Increasing Recovery of Precious Metals from Porphyry Copper Ore in Pulang Copper Mine Yunnan

Experimental Study of a Lead-zinc Polymetallic Ore Containing Highly Pyrite From Yunnan Province

Mineral Processing Technical Study of Cu-Pb-Zn Mutil-Metal Sulfide Ore which contains a lot of Pyrrhotite in Yunnan

Experiment Study on New Processing of a Mixed Flotation of Recoverying Complex Copper-Lead-Zinc Polymetallic Sulphide Ore

Research on Beneficiation Technique to Improve Recovery of Deep Mined Copper Ore

Experimental Study on Comprehensive Recovery of Valuable Minerals from Flotation Tailings in Copper-Molybdenum Mine

Research on Bulk Floatation Discarding Tailing of Copper and Zinc Polymetallic Sulfide Ores

Study on Recovery of Lead-Zinc Tailing Ore by Electrochemical Flotation

Simultaneous recovery of arsenic and copper from copper smelting slag by flotation: Redistribution behavior and toxicity investigation

Study on Flotation of a Refractory Copper-zinc Polymetallic Sulfide Ore

Flotation of Copper Sulfide Ore Using Ultra-Low Dosage of Combined Collectors

Study on technological mineral characteristic of mixed ore and recovering As

Study on the influence of cyclone convex structure on copper separation

Experimental Study on Iron Separation From a Lead -Zinc Tail in Yunnan Province

Copper recovery improvement in an industrial flotation circuit: A case study of Sarcheshmeh copper mine

Experimental Research on Beneficiation Process a Low-grade Cu-Pb-Zn Polymetallic Sulfide Ore from Xinjiang

Pyrometallurgical Recovery of Valuable Metals from Flue Dusts of Copper Smelter Through Lead Alloy

Study on the mineral processing technology of a high Ca-Mg contents and sulphide-oxide mixed copper-cobalt ore in Congo (Kinshasa)

Advances in Recovery of Valuable Metals and Waste Heat from Copper Slag

A Review of the Comprehensive Recovery of Valuable Elements from Copper Smelting Open-Circuit Dust and Arsenic Treatment

Study on Separation of Pb and Zn from Mixed Rougher Concentrates