Magnets for HIRFL-CSR Rings

P. Yuan,X. Q. Zhang,B. Zhang,G. P. Sun,Y. He,L. Z. Ma,W. J. Wang,F. Wang,C. A. Xie,D. Y. Xu,W. J. Liu,S. F. Han,J. W. Xia,W. L. Zhan

DOI: https://doi.org/10.1109/tasc.2005.869718

IF: 1.9489

2006-01-01

IEEE Transactions on Applied Superconductivity

Abstract:The magnet design, fabrication, and measurement of HIRFL-CSR (Heavy Ion Research Facility in Lanzhou Cooling Storage Ring) are presented. All magnets will be laminated and welded with an armor-coated surface between two big endplates made of sticking glue 0.5 mm-thick sheets. The dipole of CSRm was chosen an H type with an air circle on the pole to improve the field uniformity. The dipole of CSRe was chosen the C type with an air circle and two air slots on the pole to improve the field homogeneity. Its reproducibility of magnet to magnet was adjusted with inserting small laminating pieces before demountable pole ends to reach less than plusmn2times10-4 at optimized field level. CSRm quadrupoles diameter is 170 mm and has two different lengths, and its endplates were made with punching pieces after coating with epoxy glue, there is chamfered directly on the pole ends to reduce 12th-order contribution of field and without the demountable pole ends. CSRe main quadrupoles diameter is 240 mm and has two different lengths, and its endplates were also made with punching pieces coated with epoxy glue, there is also chamfered directly on the pole ends to reduce 12th-order contribution of field like CSRm