Abstract:Perovskite oxide La0.6Sr0.4Co0.2Fe0.8O3-delta (LSCF6428), a wonderful electronic-ionic conductor could be used as cathode of solid oxide fuel cell (SOFC). Graded cathode with coarse layer and fine layer, could improve the diffusion rate and electrochemical reaction activity of oxidant. The fabrication and properties of graded LSCF6428 cathode were discussed in this paper. First, pure perovskite LSCF6428 powders were prepared by citrate-EDTA method (CEM), citrate method (CM) and solid phase synthesis (SPS). The powders with higher specific surface area and smaller grain size are easier to be sintered and densified. Single LSCF6428 cathode with thickness of 30 mu m was prepared by SPS powders, the porosity of cathode was high about 30% and pore size was about 5 mu m. Graded LSCF6428 cathode including 30 gm outer layer and 10 mu m inner layer was prepared by SPS and CM powders, respectively. Clear double-layer cathode was observed by SEM, which combined tightly and transited gradually. Porosity of outer layer is high about 30% and pore size is about 1-5 mu m; inner layer is finer and pore size is about 0.2-1 mu m. Based on the above research, 300 mu m yttria stabilized zirconia (YSZ) electrolyte supported cell with single LSCF6428 cathode and double-layer LSCF6428 cathode were prepared, and the properties of two type cells were tested in H-2. Power density of graded cell is 197 mW cm(-2) at 950 degrees C, and improved about 46% comparing that of single layer LSCF6428 cell (135 mW cm(-2)). (C) 2007 Elsevier B.V. All rights reserved.

Preparation and characterization of graded SSC–SDC MIEC cathode for low-temperature solid oxide fuel cells

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

Preparation and Performance of Nanostructured Porous Thin Cathode for Low-Temperature Solid Oxide Fuel Cells by Spin-Coating Method

Synthesis of functionally graded cathodes for intermediate temperature solid oxide fuel cells

Preparation and characterization of nanocrystalline Ce0.8Sm0.2O1.9 for low temperature solid oxide fuel cells based on composite electrolyte

A composite oxygen-reduction electrode composed of SrSc 0.2Co0.8O3-δ perovskite and Sm 0.2Ce0.8O1.9 for an intermediate-temperature solid-oxide fuel cell

Properties and Performance of Ba0.5Sr0.5Co0.8Fe0.2O3−δ + Sm0.2Ce0.8O1.9 Composite Cathode

Composite Electrolyte Based On Nanostructured Ce0.8sm0.2o1.9 (Sdc) For Low-Temperature Solid Oxide Fuel Cells

High performance proton-conducting solid oxide fuel cells with a stable Sm0.5Sr0.5Co3-δ-Ce0.8Sm0.2O2-δ composite cathode

Developing an ultrafine Ba0.5Sr0.5Co0.8Fe0.2O3-δ cathode for efficient solid oxide fuel cells

Electrochemical Performance of a Solid Oxide Fuel Cell Based on Ce0.8Sm0.2O2−δ Electrolyte Synthesized by a Polymer Assisted Combustion Method

Optimization of Sm0.5sr0.5coo3-Delta-Infiltrated Ysz Electrodes for Solid Oxide Fuel Cell/Electrolysis Cell

Synthesis and Characterization of SmSrCo2−xMnxO5+δ (x=0.0, 0.2, 0.4, 0.6, 0.8, 1.0) Cathode Materials for Intermediate-Temperature Solid-Oxide Fuel Cells

A cobalt-free composite cathode prepared by a superior method for intermediate temperature solid oxide fuel cells

Fabrication and Electrochemical Characterization of Anode-Supported Microtubular Solid Oxide Fuel Cells Based on Ce0.8sm0.2o2-D Electrolytes

Preparation and Characterization of Graded Cathode La0.6Sr0.4Co0.2Fe0.8O3−δ

High performance layered SmBa0.5Sr0.5Co2O5+δ cathode for intermediate-temperature solid oxide fuel cells

Preparation And Characterization Of Graded Cathode La0.6sr0.4co0.2fe0.8o3-Delta

A new Co‐based cathode with high performance for intermediate‐temperature solid oxide fuel cells

Preparation and characterization of Sm0.2Ce0.8O1.9/Na2CO3 nanocomposite electrolyte for low-temperature solid oxide fuel cells

Novel SrSc0.2Co0.8O3− As a Cathode Material for Low Temperature Solid-Oxide Fuel Cell