Abstract:Reversible heat pumps are key technologies for the decarbonization of space heating and cooling in buildings. Considering the ongoing research on these technologies, it is important to build models that better describe heat pump operation when installed in the field, allowing for a more precise estimation of energy savings. Most studies are usually based on models that reproduce heat pump operation at part load by correcting factors taken from Standards or catalogs. The risk of incorrectly estimating the achievable energy savings is therefore real, as is the adoption of physically unfeasible operating strategies. The present study compares an approach based on correcting factors, with a more complete one in which both the thermodynamic model and control are considered. For an office building in the Mediterranean region, the performance of an air-to-water heat pump is evaluated using both approaches during the entire heating and cooling seasons and in the case of a demand response event. The results show that the typical approach leads to a large variation in estimated performance in the case of low demand with a percentage variation of more than 50%. In addition, about 15.3% overestimation in carbon dioxide emissions is found. In the case of a demand response event that involves reducing the temperature setpoint of the heat pump, disregarding the controller's action could lead to a significant underestimation (from 65% up to 118%) of the achievable energy savings. Additionally, the integrated approach revealed a compressor overcycling in the case of controller dead-band variation (more than 12 compressor cyclings in one hour), which could not be detected by a simplified approach. This study confirms the importance of including a more comprehensive modeling of heat pumps in energy flexibility studies to obtain more accurate estimate of the achievable energy and environmental impacts.

Optimal heat-transfer areas for endoreversible heat pumps

Optimal Heat Exchanger Area Distribution and Low-Temperature Heat Sink Temperature for Power Optimization of an Endoreversible Space Carnot Cycle

Optimum allocation of heat transfer surface area for heating load and COP optimisation of a thermoelectric heat pump

Optimal Allocation of Heat Exchanger Area for Vapor-Compression Heat Pump Plants

Optimum Allocation of Heat Exchanger Area of a Thermoelectric Heat Pump

Performance Modeling and Testing on a Heat-Regenerative Adsorptive Reversible Heat Pump

THERMODYNAMICS MODEL AND PERFORMANCE OPTIMIZATION OF ABSORPTION HEAT PUMP

INFLUENCE OF OPERATING PARAMETERS ON PERFORMANCE OF HEAT- REGENERATIVE ADSORPTIVE REVERSIBLE HEAT PUMP

THERMODYNAMIC OPTIMIZATION OF COUPLED HEAT WORK CONVERSION AND HEAT TRANSFER ENERGY SYSTEMS BY APPLYING INVERSE PROBLEM AND VARIATION METHOD

Optimal design for dual-stage high temperature heat pump by heat exchange area simulation

Power Optimization of a Closed Brayton Cycle with Endo-reversible Intercooling and Regenerative Heating

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

Optimal Procedure Of Heat Exchanger Design And Its Application On Dual-Stage-Circle High Temperature Heat Pump

Study on the optimization of heat loss during operation of air source heat pump based on entransy theory

Multi-factor Coupling Optimization of Heat Recovery Effectiveness in a Transcritical CO2 Heat Pump

Heat Engine Cycle Configurations for Maximum Work Output with Generalized Models of Reservoir Thermal Capacity and Heat Resistance

Three-heat-reservoir thermal Brownian heat pump and its performance limits

Optimization Criteria for the Performance of Heat and Mass Transfer in Indirect Evaporative Cooling Systems

Heat Current Method for Analysis and Optimization of Heat Recovery-Based Power Generation Systems

Mapping the performance of reversible air-to-water heat pump for improving energy savings estimation in energy flexibility scenarios

A Collaborative Optimization Method for Heat Transfer Systems Based on the Heat Current Method and Entransy Dissipation Extremum Principle