Abstract:Periodic sound reduction at some frequencies and high pressure loss could be considered as the disadvantages of simple expansion silencers. Generally, reactive elements are applied in silencers to optimize their acoustic and aerodynamic performance. In this paper, we were going to investigate the combined and independent effects of reactive elements, baffle and extended tubes at the inlet and outlet of simple expansion silencer, on the acoustic performance and pressure loss of simple expansion silencer. Firstly, simple expansion silencer dimensions were determined based on theoretical calculations to attenuate the noise by 10 dB. Secondly, the simulation was performed using COMSOL acoustical module software based on finite element method to predict silencer sound transmission loss and pressure loss, respectively, before and after adding reactive elements. Then, according to ISO7235, ISO3744 and ISO3746 standards noise insertion loss of various silencers under study was measured in a free field and in the following that silencers pressure loss evaluated. Finally, the predicted results with the software were compared with the experimental ones. The addition of the extended tubes increased the transmission loss and insertion loss at low and medium frequencies and mitigated the pressure loss of the silencer compared to the simple expansion silencer. The baffle increased the transmission loss curve in the medium frequencies compared to the simple expansion silencer. The combination of baffle and extended tube elements caused an extraordinary increase in insertion loss and transmission loss at the medium frequencies and a decrease in pressure loss. It could be concluded from the present study that using extended tube might be probably the best choice to reduce pressure loss and increase the acoustic performance of simple expansion silencer at low and medium frequencies and what's more is that the best acoustic performance in medium frequencies can be achieved by using a combination of baffle and extended tube.

ACOUSTIC ATTENUATION PERFORMANCE OF CIRCULAR EXPANSION CHAMBERS WITH OFFSET INLET/OUTLET: I. ANALYTICAL APPROACH

Performance Analysis of Dual-Channel Inward-Turning Inlets under Off-Design Conditions

Numerical Analysis of Acoustic Characteristic of Muffler with Complicated Structure and Structural Optimization

Numerical Simulation and Structure Optimization of Compressor Muffler

Simulation and Improvement of Silencer at Turbocharger Outlet

Acoustic attenuation analysis of expansion chamber mufflers with non-uniform cold and hot flow

Corrected One-Dimensional Approach for the Acoustic Simulation of Expansion Chamber Silencer

Study of acoustic and aerodynamic performance of reactive silencer with different configurations: Theoretical, modeling and experimental

Impedance-to-scattering Matrix Method for Large Silencers Part II: Integral Formulation, Acoustic Reciprocity and Practical Issues

Analysis of coupling effect between chambers of reactive muffler

Calculation model of transmission loss for arrayed elements dissipative silencers

Acoustic attenuation prediction and analysis of perforated hybrid mufflers with non-uniform flow based on frequency domain linearized Navier-Stokes equations

Boundary Element Analysis of Bar Silencers Using the Scattering Matrix with Two-Dimensional Finite Element Modes

Acoustic Simulation for Exhaust Silencer of Vehicle Engine with Combined One/Three-Dimensional Approach

A three-dimensional analytical approach for large rectangular splitter silencers in the presence of mean flow

Nonlinear Acoustic Behavior Prediction and Analysis of Straight Through Perforated Tube Silencer With Flow

Acoustic modelling and analyses of geometrically complex systems with Micro-perforated panels

Influence of perforation and sound-absorbing material filling on acoustic attenuation performance of three-pass perforated mufflers

Optimizing acoustic liner conditions for noise control: A study of flexible components and restraint conditions

A mode-matching analysis of flexible shells and waveguides with partitioning and muffler conditions

A three dimensional investigation into the acoustic performance of dissipative splitter silencers