Abstract:The cooling system is the auxiliary equipment that consumes the most energy in a data center, accounting for about 30 to 50% of the total energy consumption. In order to effectively reduce the energy consumption of a data center, it is very important to improve the heat exchange efficiency at the chip level. Compared with air cooling, single-phase cold plate liquid cooling, and immersion liquid cooling, the flat loop heat pipe (FLHP) is considered to be a better chip-level cooling solution for data centers. It has extremely high heat transfer efficiency and heat flux variability, and it can avoid the operation risk caused by liquid entering the server. In this paper, a FLHP with an evaporator designed with a "Tesla valve" flow channel configuration is developed. Experiments on the FLHP are carried out, focusing on the installation angles and cooling condition factors. The results show that an inclination angle of 20° is the critical point of the influence of gravity on the performance of the FLHP; to ensure good operation of the FLHP, the installation angle should be greater than 20°. The equivalent heat transfer coefficients of the FLHP condenser under different cooling conditions are calculated. It is found that water cooling can provide higher cooling heat transfer coefficients with lower energy consumption and operating noise. Additionally, the heat transfer limit, operating temperature uniformity, and start-up stability of the FLHP are significantly improved under water cooling conditions. The maximum heat load of the FLHP is up to 230 W, and the temperature difference of the evaporator surface can be controlled within 0.5 °C, under 20 °C water cooling. Finally, using the FLHP for thermal management of the chip, its heat transfer efficiency is 166 and 41% higher than that of air cooling and water cooling, respectively.

Applied Investigation on LED Heat Cooling Equipment Using Flat Micro-Heat Pipe Arrays

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Thermal Analysis and Design of High-Power LED Street Light

Study on LED Array Heat Radiator Improvement under Natural Convection

Experimental Study and Taguchi Analysis on LED Cooling by Thermoelectric Cooler Integrated with Microchannel Heat Sink

Thermal Design Based on Thermosyphon Heat Sink of High-Power LED Street Light

Study on LED array heat transfer under natural convection based on CFD

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Orientation Effects on Natural Convection Heat Dissipation of Rectangular Fin Heat Sinks Mounted on LEDs

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

The Study on High-effect and Mechanism of Heat Dissipation of Tunnel LED

Study on collaborative enhancement of led heat dissipation characteristics by pulsating heat pipe and heat pipe

Fluid Flow and Heat Transfer Characteristics of Liquid Cooling Microchannels in LTCC Multilayered Packaging Substrate

Orthogonal study and analysis of variance on a thermal management system for high-power LED package.

Study on the Water Cooling Technology for the High Power LED Array

Experimental investigation on a 0.5-metre-long aluminum flat heat pipe for thermal management in electronic devices

Experimental Investigation on the Thermal Performance of a Large-Size Aluminum Vapor Chamber for Multi-Point Heat Sources

Influences of Heat Sink on Cooling Capability for LED Lamp

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Experimental investigation on thermal performance of ultra-thin flattened heat pipe with middle heating for electronics cooling

Effects Analysis of Environment Temperature and Air Flow on Heat Dissipation of LED Lightings