Abstract:Direct internal reforming solid oxide fuel cells (DIR-SOFCs) are economically viable devices for power generation, while their reliability requires further improvement. Advanced process control can effectively facilitate the long-term operation of SOFCs with high efficiency and safety. DIR-SOFCs exhibit complex coupling effect and a high degree of nonlinearity, making it worthwhile to embed high-quality dynamic models including spatial distributions into nonlinear model predictive control (NMPC). A two-layer control architecture aiming for rapid load tracking and thermal management with high economic efficiency is designed for planar DIR-SOFCs, containing a set point optimizer and an NMPC controller based on the distributed parameter model expressed by partial differential–algebraic equations (PDAE). PDAE-constrained dynamic optimization problems are solved in the NMPC controller to seek optimal control strategies, considering safety constraints about the maximum temperature gradient and physical constraints of actuators. The high-fidelity one-dimensional PDAE model is validated through steady and dynamic simulations, and the optimal steady-state distributions are analyzed under three power demands. Behaviors of the closed-loop system under power demand step-up and step-down scenarios are investigated to demonstrate the effectiveness of the designed control scheme. The proposed NMPC controller can efficiently realize rapid load tracking, maintain good thermal management, and reduce the transition time, with minor steady-state errors and acceptable real-time performance.

Generalized Predictive Control for Fractional Order Dynamic Model of Solid Oxide Fuel Cell Output Power

Predictive Control of SOFC Based on a GA-RBF Neural Network Model

Multiple Model Predictive Hybrid Feedforward Control Of Fuel Cell Power Generation System

Thermal Management of an Independent Steam Reformer for a Solid Oxide Fuel Cell with Constrained Generalized Predictive Control

Multi-objective Optimal Control of a Steam Reformer Solid Oxide Fuel Cell System

Constrained model predictive control of a solid oxide fuel cell based on genetic optimization

Fuzzy Dynamic Modeling and Predictive Load Following Control of a Solid Oxide Fuel Cell Power System

Nonlinear Model Predictive Control Based on the Moving Horizon State Estimation for the Solid Oxide Fuel Cell

Fuzzy Model Predictive Control of Solid Oxide Fuel Cell with Zone Tracking

Study on an Adaptive Multi-Model Predictive Controller for the Thermal Management of a SOFC-GT Hybrid System

Feedforward and Desired Dynamic Equation Control for Solid Oxide Fuel Cell System.

Multiple model predictive control for solid oxide fuel cells

Voltage and Fuel Utilization Control for Solid Oxide Fuel Cells with Combined L1 Adaptive – Predictive Control Strategy

A Novel Adaptive Model Predictive Control Strategy of Solid Oxide Fuel Cell in DC Microgrids

Nonlinear model predictive control of direct internal reforming solid oxide fuel cells via PDAE-constrained dynamic optimization

Predictive control of solid oxide fuel cell based on an improved Takagi–Sugeno fuzzy model

Advanced Self-Adapted Predictive Control Strategy for High-Power Vehicular Fuel Cell System Thermal Management

Current-based MPC for Operating-Safety Analysis of a Reduced-Order Solid Oxide Fuel Cell System

Thermoelectric Tracking Control of Solid Oxide Fuel Cell System Using Adaptive Dynamic Programming

L1 Adaptive Output Feedback Controller with Operating Constraints for Solid Oxide Fuel Cells.

Data-driven Nonlinear Control of a Solid Oxide Fuel Cell System