Abstract:The paper describes physical and numerical simulations of a manufacturing process composed of hot forging and controlled cooling, which replace the conventional heat treatment technology. The objective was to investigate possibilities and limitations of the heat treatment with the use of the heat of forging. Three steels used to manufacture automotive parts were investigated. Experiments were composed of two sets of tests. The first were isothermal (TTT) and constant cooling rate (CCT) dilatometric tests, which supplied data for the identification of the numerical phase transformation model. The second was a physical simulation of the sequence forging-cooling on Gleeble 3800, which supplied data for the validation of the models. In the numerical part, a finite element (FE) thermal-mechanical code was combined with metallurgical models describing recrystallization and grain growth during forging and phase transformations during cooling. The FE model predicted distributions of the temperature and the austenite grain size in the forging, which were input data for further simulations of phase transformations during cooling. A modified JMAK equation was used to calculate the kinetics of transformation and volume fraction of microstructural constituents after cooling. Since the dilatometric tests were performed for various austenitization temperatures before cooling, it was possible to include austenite grain size as a variable in the model. An inverse algorithm developed by the authors was applied in the identification procedure. The model with optimal material parameters was used for simulations of hot forging and controlled cooling in one of the forging shops in Poland. Distributions of microstructural constituents in the forging after cooling were calculated. As a consequence, various cooling sequences during heat treatment could be analyzed and compared.

Finite Element Analysis for JTS Forging with One-dimensional Temperature Gradient

Finite element analysis of heavy forging processing with JTS method

Optimization of hot deformation parameters for multi-directional forging of Ti65 alloy based on the integration of processing maps and finite element method

Transformation characteristics of temperature and phases within Ti-6Al-4V aeroengine drum in hot forging and air cooling procedures

Optimization of Forging Process Parameters and Prediction Model of Residual Stress of Ti-6Al-4V Alloy

The Effect of the Forging Process on the Microstructure and Mechanical Properties of a New Low-Cost Ti-5Al-1.5Mo-1.8Fe Alloy

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts

Casting Design Optimization Using Numerical Simulation of Precision Forging Die for Large Titanium Alloy Integral Bulkhead

Hot Workability of a Typical Ultrahigh Strength Steel During the Isothermal Forging Process

Predictive Modeling and Optimization of Hot Forging Parameters for AISI 1045 Ball Joints Using Taguchi Methodology and Finite Element Analysis

Dynamic Mechanical Properties and Modified Material Constitutive Model for Hot Forged Ti2AlNb over Wide Ranges of Temperature and Strain Rate

Research on hot deformation behavior and numerical simulation of microstructure evolution for Ti–6Al–4V alloy

Influence of forging velocity on temperature and phases of forged Ti-6Al-4V turbine blade

FEM model optimization study of mechanical properties and material selection in stamping process

Numerical simulation of microstructure evolution of flange axle during hot forging

Efficient phase-field simulation for linear superelastic NiTi alloys under temperature gradients

Finite Element Modelling of Tensile Test for Micro-Alloyed Low Carbon Steel at High Temperature

Research on Hot Forging Process of C-Grade Steel Train Wheel by Fem

Electrical-thermal-mechanical coupled modeling and simulation on deformation behaviors of Ti6554 alloy in electrically-assisted micro-tension

A New Method for Controlling Billet Temperature During Isothermal Die Forging of a Complex Superalloy Casing