Abstract:The C=C double bonds in the main chain of hydroxyl-terminated polybutadiene (DHTPB), obtained by the degradation of polybutadiene rubber, were partially epoxided using m-chloroperoxybenzoic acid (mCPBA) as epoxidation reagent. A series of epoxided HTPBs (EHTPB) with different epoxy contents (5%, 10% and 15%) were prepared by tuning the molar ratio of mCPBA to C=C double bonds. The structures of EHTPBs were characterized by Fourier transform-infrared (FTIR), nuclear magnetic resonance (H-1-NMR) spectroscopy and gel permeation chromatography (GPC). The epoxy percent in EHTPBs from H-1-NMR spectra was in accordance with the design. In addition, a series of EHTPB-based polyurethane elastomers (EPU) were prepared by the reaction between EHTPB and 4,4'-diphenylmethane diisocyanate with 1,4-butanediol as a chain extender. Mechanical and thermal properties of the EPU samples were characterized by tensile test, differential scanning calorimetry (DSC) and thermal gravity analysis (TGA). With increased epoxy percent in EHTPB, the Young's modulus and the tensile strength of the EPU samples increased, whereas the elongation at break decreased. The sample EPU10 prepared with 10% of epoxy had the best mechanical properties with 8.82 MPa as Young's modulus, 7.83 MPa as tensile strength, and (485 +/- 23)% as elongation at break. The elasticity recovery of the EPU sample was slightly better than HTPB-based PU (EPU0). The results with TGA test showed that the thermal degradation of EPU, similar to EPU0, was divided into three stages. However, the EPU samples had better thermal stability with the initial degradation temperature at 210 degrees C, about 30 degrees C higher than that of EPU0. The DSC results showed that the glass transition temperature (T-g) of EPU gradually increased as epoxy percent was increased, though still lower than that of HTPB (FHTPB) based PUs prepared by free-radical polymerization.

In situ epoxidation of ethylene propylene diene rubber by performic acid

Preparation and Properties of Epoxided Hydroxyl-terminated Polybutadiene Based Polyurethane Elastomers

Epoxidation of propylene to propylene oxide catalyzed by μ-oxo-bismetalloporphyrins

110Th Anniversary: the Epoxidation of Polybutadiene Via Reaction-Controlled Phase-Transfer Catalysis

Off-line analysis in the manganese catalysed epoxidation of ethylene-propylene-diene rubber (EPDM) with hydrogen peroxide

In Situ Efficient End Functionalization of Polyisoprene by Epoxide Compounds via Neodymium-Mediated Coordinative Chain Transfer Polymerization

Kinetics of Epoxidation and Oxirane Cleavage of Fatty Acid Methyl Ester in Formic Acid Auto Catalytic System

Conversion of Fatty Acid Methyl Ester to Epoxy Plasticizer by Auto-Catalyzed in Situ Formation of Performic Acid: Kinetic Modeling and Application of the Model

Degradation autocatalytic epoxidation of oleic acid derived from palm oil via in situ performic acid mechanism

Mass Transfer and Reaction Kinetics of Soybean Oil Epoxidation in a Formic Acid‐autocatalyzed Reaction System

Synergistic hybrid catalyst synthesis for epoxidation of linoleic acid via in situ performic acid

Epoxidation modification of strictly alternating copolymer via living and controlled anionic alternating copolymerization of 1,3-pentadiene and styrene derivatives

Preparation of Epoxidized Fatty Acid Methyl Ester with in situ Auto-Catalyzed Generation of Performic Acid and the Influence of Impurities on Epoxidation

Synergistic catalytic epoxidation of palm stearin applied by in situ peracid mechanism

In Situ Epoxidation of Hybrid Oleic Acid Derived from Waste Palm Cooking Oil and Palm Oil with Applied ZSM-5 Zeolite as Catalyst

Introducing Mechanochemistry into Rubber Processing: Green-Functionalized Cross-Linking Network of Butadiene Elastomer

Optimization Of Epoxidized Methyl Acetoricinoleate Synthesis By Response Surface Methodology

Polymer Blends of Pbt and Pp Compatibilized by Epoxidized Ethylene Propylene Diene Rubber

A DFT study of epoxidation of propylene on dimer MoO(x)

Synthesis of an Addition-Crosslinkable, Silicon-Modified Polyolefin via Reactive Extrusion Monitored by In-Line Raman Spectroscopy

Modification of Natural Rubber Latex with Peracetic Acid