Abstract:Using Lagrangian Coherent Structures, the influences of synthetic jet parameters, namely, velocity and frequency, on lift at post-stall attack angle are studied in detail, from viewpoint of mass transport. First, the pressure coefficient distribution and the Lagrangian Coherent Structures evolution process of the non-controlled airfoil and the controlled airfoil, at a post-stall attack angle, are compared with each other through numerical simulation, and hence the influences of the mass transport process on the lift coefficient are discussed. Then, the mass transport process and its influences on the lift coefficient under different jet velocities and frequencies are analyzed further. As the conclusion, it can be drawn that there are mainly four routes to enhance the lift of airfoil at post-stall attack angle using synthetic jet, that is, (a) The synthetic jet can directly improve the fluid momentum of the boundary layer in the middle section of the suction surface; (b) The suction phase of the synthetic jet significantly reduces the pressure on the front section of the airfoil suction surface; (c) The synthetic jet could carry the high momentum fluid from the mainstream into the separation zone at the rear section of the airfoil, thus reducing the suction surface pressure of the rear section; (d) The tail vortex reduces the pressure on the suction surface of the airfoil tail. In particular, the jet parameters affect the lift coefficient by these four routes. Specifically, the fluid momenta of the boundary layer in both the front and middle sections of the suction surface are greatly increased with the jet velocity, and the contributions of the tail vortex and the high momentum fluid from the mainstream to the lift are reduced with the jet velocity. As for jet frequency, the contributions of the tail vortex and the high momentum fluid from the mainstream to the lift are reduced with the increase of jet frequency.

Experimental study on vortex-control technology of canard-spanwise synthetic jet actuators on close-coupled canard configuration

Lift Augmentation Potential of the Circulation Control Wing Driven by Sweeping Jets

Near field evolution of wingtip vortices under synthetic-jet based control

Enhancing Lift on a Flat Plate Using Vortex Pairs Generated by Synthetic Jet

Lagrangian Analysis on Routes to Lift Enhancement of Airfoil by Synthetic Jet and Their Relationships with Jet Parameters

Aerodynamic performance improvement of a pitching airfoil via a synthetic jet

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Numerical Analysis Of Active Flow Control Around Airfoil By Synthetic Jet Technology In Low Reynolds Number

Enhancement of aerodynamic performance of a heaving airfoil using synthetic-jet based active flow control

Spanwise Control Authority of Synthetic Jets on a Stalled Airfoil

The aerodynamic behavioral study of canard plane with fan wing configuration

On the effect of active flow control on the meandering of a wing-tip vortex

Wind-tunnel tests of synthetic jet control effects on airfoil flow separation

Aerodynamic Analysis and Design Numerical Simulation of the Vortex Flow over a Common Research Model with Flying-Wing Configuration

Experimental Study on the Water Entry of a Vehicle with a Single Canard Wing at an Initial Angle of Attack

Nonlinear Control Laws for a Wind Tunnel Free-flight Study of a Canard Aircraft

Wing design optimization and stall analysis with Co-flow Jet active control

Experimental Investigation of Enhancing Wing Aerodynamic Performance by Plasma Synthetic Jet

Experimental Study on Vertical Water Entry of the Projectile with Canard-Wing

Experimental Investigation on Aerodynamic Interactions of Canard Rotor/Wing Aircraft in Hover and Low Speed Forward Flight

Modulation of driving signals in flow control over an airfoil with synthetic jet