Fuzzy control of injection pressure of injection molding machines based on a nonlinear function

GUAN Cheng,PENG Hua
DOI: https://doi.org/10.3785/j.issn.1008-973X.2011.08.009
2011-01-01
Abstract:According to the specialty of injection molding machine with servo motor and constant pump,a nonlinear dynamic model of injection hydraulic system was set up.Based on a nonlinear conic,a new type closed-loop pressure control was proposed to improve the control precision of injection pressure.A method of flow control was presented to create a nonlinear function with the help of the difference of pressure,and a fuzzy control method is used to adjust controller parameter on line to overcome uncertainties of parametric and load of hydraulic system,by which the flow signal was optimized,and the design of the point where the velocity control is switched to pressure control could be avoided.A PI control is combined to realize pressure tracking.The experimental and simulating results show that the proposed method can satisfy the requirement for injection pressure of injection molding machine and has good self-adapting character.The steady state pressure fluctuation is less than 0.1 MPa,which verifies the effective of this method.
What problem does this paper attempt to address?