Abstract:High speed power chucks are important function units in high speed turning. The gripping force loss is the primary factor limiting the rotational speed of high-speed power chucks. This paper proposes a piecewise model considering the difference of wedge transmission’s radial deformation between low-speed stage and medium-to-high-speed stage, the friction forces of chuck transmission, and the compressibility of hydraulic oil in rotary hydraulic cylinders. A corrected model of gripping force loss is also established for power chucks with asymmetric stiffness. The model is verified by experiment results. It is helpful to use the piecewise model to explain the experimental phenomenon that the overall loss coefficient of gripping force increases with the rotational speed increasing at medium and high speed stages. Besides, the loss coefficients of gripping force at each stage during speeding up and the critical rotational speed between two adjacent stages are discussed. For wedge power chucks with small wedge angel ( α <20°) and ordinary lubrication (µ 0 >0.06), the local loss coefficient of gripping force at the low speed stage is about 70% of that at the medium to high speed stage. For wedge power chucks with larger wedge angel ( α >20°) or low friction coefficient (µ 0 <0.06), the wedge transmissions cannot self-lock at high speed stage, and the gripping force loss at the high speed stage is related to the hydraulic lock and hydraulic oil in the rotary hydraulic cylinder; the local loss coefficients of gripping force at the third stage is about 1.75 to 2.13 times that at the second stage. This work is helpful to understand the mechanism of the gripping force loss thoroughly and to optimize power chucks.

Computational Model for the Critical Rotational Speed of an HSK Tool Holder

Research On Hsk Tool Holder Critical Rotary Speed Computational Model

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Inherent Characteristics and Dynamic Response Analysis of High-Speed Cutting-Tool System

Simulation of Chip Formation in High-Speed Hard Machining

Optimization for the Connection Parameters of Hsk Tool Shanks

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Analysis on the stiffness of angular contact ball bearings and its effect on the critical speed of a high speed motorized spindle

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Finite Element Simulation of High-Speed Cutting

Thermo-mechanical Coupling Analysis of a High-Speed Actuating Mechanism Based on a New Thermal Contact Resistance Model

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Clamping Technology Optimization of High Speed Machining of NOMEX Honeycomb Core Based on Milling Force Model

Trochoid-path-based FEM Simulation for High-Speed Milling of Aluminum Alloy

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Modelling and Characteristic Investigation of Spindle-Holder Assembly under Clamping and Centrifugal Forces

Characteristics of stiffness and contact stress distribution of a spindle-holder taper joint under clamping and centrifugal forces

Piecewise Model and Experiment of Power Chuck's Gripping Force Loss During High Speed Turning

Jaw-chuck stiffness and its influence on dynamic clamping force during high-speed turning