Abstract:In this article, we present a four-channel direct digital synthesis (DDS) design that operates with a common clock ranging from 500 MHz to 24 GHz and generates output frequencies up to 1.75 GHz. A key feature of this board is its custom field-programmable gate array (FPGA)-based synchronization method, which ensures alignment accuracy of 170 ps between the channels, enabling precise frequency and phase relationship settings. In addition, the DDS board incorporates a user-friendly web interface that allows for continuous control and monitoring capabilities over TCP/IP. Multiple synchronized channels can be power-combined to produce a low-phase noise output due to coherent addition of the common carriers and the noncoherent addition of the residual DDS noise. By exploiting these principles and combining eight parallel channels of two DDS boards, we achieve exceptional residual phase noise performance, with L(1Hz)=-147dBc/Hz and L(100kHz)=-180dBc/Hz for a 9.765625 MHz output signal. These noise levels surpass the previously reported results achieved with regenerative frequency dividers. We also present a method for obtaining accurate residual noise measurements using an absolute phase modulation (PM) noise and amplitude modulation (AM) noise nalyse. Furthermore, we nalyse the phase alignment tolerances required to minimize the AM-to-PM and PM-to-AM conversion that commonly occurs in power-combined signals. Finally, we demonstrate the synthesis of a highly stable 9.765625 MHz signal obtained from a cavity-stabilized optical frequency comb (OFC), with an absolute white phase noise of -180 dBc/Hz.

DDS Chip AD9956 and Its Application

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

The Spurious Analysis and Suppression in DDS Chip

A Dds-Based C-Band Wideband Agile Frequency Synthesizer

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

A Method for Improving the Laser Diffraction Efficiency During Frequency Shifting

High-accuracy Control System Based on DDS for Laser Frequency and Its Applications

Design of C-band wide band small step and low phase noise frequency source based on DDS

Spread Spectrum Signal Generator Based on DDS Technology

Comparison of linearly sweep characteristics for ADI DDS

Ultra-Low Phase Noise Frequency Division With Array of Direct Digital Synthesizers

A Low Spurious and Small Step Frequency Synthesizer Based on PLL-DDS-PLL Architecture

A 2ghz Direct Digital Frequency Synthesizer Based on Multi-Channel Structure

Development of DDS Digital Synthetic Frequency for Chirp Signal Generation

DDS Based Radar Signal Generator for Microwave Remote Sensing

Chip Timing Synchronization in DS-CDMA IF Receiver by Selecting Samples

A Millimeter-Wave Frequency Synthesizer Architecture with High Agility and High Resolution Performance

Designing of Agilely Hopping-frequency Synthesizer at Ka-band

Simulator for hopping-frequency microwave synthesizer based on DDS and PLL

Design and Completion for Waveform Generator Based on DDS

Application of DDS Technology in Driving High Frequency Surgical Device