Abstract:This study investigates the effects of aluminum (Al) and F interactions on the coagulation behaviors of Al salts, i.e., AlCl3 and polymer aluminum chloride (PACl) at different basicity (B) towards fluoride. These coagulants achieve the optimum fluoride removal over pH 6-7, and PACl exhibits higher removal efficiency than AlCl3 does over pH 4-9. The removal of fluoride is positively correlated with the content of either Al-13 or Al-b in Al-based coagulants over pH 4-9 and increases in the order: PACl(2) > PACl(1) > AlC13. As for PACl, the increased B from 0 to 2.4 improves fluoride removal owing to the elevated ratios of Al-b. However, at further increased B to 2.8, the formation of colloidal Al species (Al-c) occurs and this effect adversely inhibits fluoride removal thereafter. The removal of fluoride by these coagulants increases with elevated initial fluoride concentrations ([F](0)) from 0 to 20 mg/L. At high [F](0) of 80 mg/L, fluoride removal by AlC13 decreases to as low as 13.1% owing to the formation of soluble Al-F complexes, as indicated from the high residual Al concentrations of 16 mg/L. Interestingly, this adverse effect can hardly be observed for PACT due to the stronger stability of Al-13 or Al-b. As for AlC13 and PACl, the introduction of fluoride changes the Al species distribution to some extent owing to the Al-F complexation, as indicated by the analysis of electrospray ionization mass spectrometry. The possible Al-F complexes formed fluoride and different Al species are proposed thereafter. PACl with diverse Al species and high Alb or Al-13 content shows higher removal efficiency towards fluoride than AlC13 does, especially at high [F](0) or under acidic pH and alkaline pH conditions. (C) 2016 Elsevier B.V. All rights reserved.

Coagulation Property of Aluminum Chloride from the Perspective of Speciation Conversion of Aluminum

Coagulation Behavior of Aluminum Salts in Eutrophic Water: Significance of Al13 Species and Ph Control

Coagulation Behaviour of Polyaluminium Chloride with Different Aluminium Speciation

[Coagulation Behavior of Al13 Species].

Coagulation Behavior of PAC with Different Aluminum Speciation Produced by Electrolysis Process

Effect of Aluminum Speciation and Structure Characterization on Preferential Removal of Disinfection Byproduct Precursors by Aluminum Hydroxide Coagulation.

Coagulation Behaviors of Aluminum Salts Towards Fluoride: Significance of Aluminum Speciation and Transformation

Relative Importance of Hydrolyzed Al(III) Species (ala, Alb, and Alc) During Coagulation with Polyaluminum Chloride: A Case Study with the Typical Micro-Polluted Source Waters

Effect of aluminum speciation on arsenic removal during coagulation process

Role of Aluminum Speciation in the Removal of Disinfection Byproduct Precursors by a Coagulation Process.

Effect of pH on the aluminum salts hydrolysis during coagulation process: formation and decomposition of polymeric aluminum species.

Humic acid removal from water with polyaluminum coagulants: Effect of sulfate on aluminum polymerization

The Transformation of Aluminium Species in the Processes of Coagulation, Sedimentation and Filtration

Transformation rule of aluminum form of Al-based coagulants in coagulation and sedimentation process

Aluminum Speciation in Polymerized Aluminum Chloride: Roles and Chloride Ion Migration in Sludge Dewatering

Aluminum speciation of coagulants with low concentration: Analysis by electrospray ionization mass spectrometry

[Coagulation performance and mechanism of Alb species in polyaluminum chloride in removing humic acid].

Modified ferron assay for speciation characterization of hydrolyzed AI(III): A precise k value based judgment

Coagulation of Humic Acid by Pacl with High Content of Al-13: the Role of Aluminum Speciation

Chemical characteristics of aluminum aqueous solution and the formation mechanism of aluminum polymer

Effect of aluminum speciation on ultrafiltration membrane fouling by low dose aluminum coagulation with bovine serum albumin (BSA)