Abstract:Reducing vehicle weight and emissions by lightweight design is a major goal of the automotive industry. Magnesium as the lightest structural metal offers a significant weight saving potential compared to steel and aluminium. Cast magnesium components are widely used, e.g. as engine blocks or gear box housings. The application of magnesium sheets is currently hampered by the low formability of magnesium which means that a large number of rolling passes is required to roll a DC cast slab to final gauge sheet. This large number of rolling steps is the main reason for the high cost of magnesium sheets. Twin-roll casting (TRC) is an alternative, economic production process for the generation of fine-grained feedstock materials that subsequently can be warm rolled to thin sheets. It therefore receives attention in actual research and development projects for the application of magnesium alloys as prospective light metal solutions. This production process for thin strips combines solidification and rolling into one single production step and therefore saves a number of rolling and annealing passes in comparison to the conventional rolling process. The main goal of the activities at the Magnesium Innovation Centre MagIC of the Helmholtz-Centre Geesthacht (HZG) is the development of wrought magnesium alloys and their introduction into industrial, structural applications. The current focus of the research work is on alloy design and their processing for magnesium sheets produced by twin roll casting. In order to understand the influence of process parameters on the microstructure and texture the first twin roll casting experiments were performed with the alloy AZ31 (Mg-3Al-1Zn-Mn) as benchmark. As an example, the influence of melt temperature on the microstructure of the strip is presented and discussed with respect to arising material properties. Optimisation of process parameters of twin roll casting and the subsequent rolling of the sheets, offers the possibility to produce high quality sheet material.

Spray Rolling Aluminum Strip For Transportation Applications

Spray Rolling Aluminum Alloy Strip

Microstructure Evolution During Spray Rolling and Heat Treatment of 2124 Al

Effect of Hot Deformation and Heat Treatment on the Microstructure and Properties of Spray-Formed Al-Zn-Mg-Cu Alloys

Optimizing mechanical property of spray formed Al-Zn-Mg-Cu alloy by combination of homogenization and warm-rolling

Microstructure Evolution and Property of Spray-Formed Cu-10 wt% Fe Alloy During Cold Rolling

Rolling of aluminum/steel bimetal plate with multi-lager spray deposition

Study on Asymmetric Rolling Process Applied to Aluminum Alloy Sheets

Formation of the primary structure of cast slabs from aluminum alloys during their twin-roll casting

Influence of Process Parameters on Twin Roll Cast Strip of the Alloy AZ31

Inline Hot Rolling of Al-5%Mg Strip Cast Using an Unequal Diameter Twin-Roll Caster

Visualizing and Quantifying Deformation Microstructures in Cold Sprayed Materials

Effect of cold rolling deformation on the microstructure and mechanical properties of spray-formed Al–Zn–Mg–Cu alloy

A new process for preparing rolled Mg/Al clad plates assisted by cold spraying ultra-thin Al particle interlayer

Studies on the New Technique of Rapid Solidification and the Mechanical Behaviors of Mocrocrystalline Alloys

Influence of Production Sequence of Aluminum Alloy Hot Rolling on Strip Surface Quality

Quantitative analysis of thin metal powder layers via transmission X-ray imaging and discrete element simulation: Roller-based spreading approaches

Research on the Microstructure and Mechanical Properties of Spray-Deposited 8009 Heat Resistant Aluminum Alloy

Devitrification-Induced Tailoring of Microstructure and Strength in Aluminum High-Entropy Alloy Powder for Cold Spray Deposition

Influence of Heat Treatment and Inter-Layer Rolling on the Evolution of Micropores in the Additively Manufactured Aluminum Alloys

Gradient-structured 1060 aluminum by air pressure-driven surface mechanical rolling treatment and its effects on the friction performance