Abstract:Surface charge accumulated on insulators plays an important role in flashover process in vacuum, which has not yet been fully understood. In this paper, charging behaviors on insulator surface were experimentally examined under negative DC and impulse voltage. For the case of DC voltage, two charging stages were observed, i.e., the area near cathode was at first negatively charged under lower voltage (stage I) and then followed by a positively charged cathode-anode surface (stage II). Surface charging at stage I is considered to be caused by Schottky injection of homo-charges from electrode into sample surface layer. While at stage II secondary electron emission (SEE) process is responsible to the positively charged anode-cathode surface. However, charging at stage I is quite sensitive to pre-stress process, as well as the electrode-insulator interface conditions. The ongoing injection of electrons from cathode can lead to gradually decreasing in surface charge accumulation as the voltage duration increases. For the case of impulse voltage, Schottky injection of homo-charges has little influence on surface charging as the time is too short for charge injection and migration in surface layer. The SEE process will govern surface charging due to its extremely fast establishment process. A good linear relationship is obtained between saturated surface charge density and applied voltage, which is generally consistent with the numerical calculation result based on secondary electron emission avalanche theory. At last, it is confirmed that the ionization of desorbed gas from insulator surface and subsequent neutralization of electrons with positive surface charge is the main cause to eliminate surface charge in flashover.

Effect of Residual Charges on Surface Discharge Propagation under Impulse Voltage

Surface Charge Characteristics on Insulators in Vacuum under Nanosecond Pulse Excitation

Analysis of Polypropylene Surface Discharge Characteristics with Pulse Sequence Analysis

Surface Forward and Backward Discharges and Corresponding Residual Charge Accumulation Characteristics under Positive Impulse

Mechanisms of charge-induced surface discharge under positive impulse voltages

The Effect of PD Process on the Accumulation of Surface Charges

Characteristics of Residual Charge Distribution on Insulator Surface under DC Voltage in Vacuum

The Effect of Surface Charge Decay on Variation of Partial Discharge Location

Investigation of Surface Discharges on Different Polymeric Materials under Hvac in Atmospheric Air

Surface Streamer Patterns Induced by a Strong Vertical Electric Field under Impulse Voltages

Residual Charge Distribution of Surface Leader Discharge under Positive Impulse Voltage

Comparison of surface charge distributions under vacuum and atmospheric condition due to surface discharge events

Competing Mechanisms of Charge-Induced Electric Field Distortion and Charge-Involved Neutralization on Surface Discharge

Experimental Investigation of Surface Charge Accumulation Behaviors on PTFE Insulator under DC and Impulse Voltage in Vacuum

Variation of surface charge distribution in PD sequences

Effect of Mechanical Vibration on Surface Discharge along Epoxy Resin under AC Electric Field

Surface Charge Accumulation Behavior and Its Influence on Surface Flashover Performance of Al2O3-filled Epoxy Resin Insulators under DC Voltages

Surface Backward Discharge Patterns under Full and Chopped Negative Impulses in C4F7N/CO2 Mixture

Influence of Surface Discharge on the Deterioration Characteristics of Ethylene‐propylene Rubber Cable Insulation under Alternating Current High Voltage

Influence Of Applied Voltage On Space Charge Formation And Accumulation Characteristics Of Low Density Polyethylene

Partial discharge characteristics of oil/polypropylene film with a needle-plate electrode excited by impulse voltages