Abstract:Nowadays, what captures consumers' primary attention is how to purchase electric vehicles with long range and desirable price. Lightweight construction stands as one of the most effective approaches for prolonging range and lowering costs. As a consequence, it is particularly imperative to undertake lightweight design optimization for the battery bracket of new energy vehicles by applying 3D printing technology. To actualize this goal, Rhino software was initially employed for 3D modeling to design the battery bracket system for a pure electric vehicle in China. Subsequently, topology optimization design of the battery bracket was carried out by adopting Altair Inspire software. Last but not least, manufacturing and assembly inspection were completed using a 3D printer. The results show that the maximum displacement of the battery lower tray bracket after topology optimization is 3.20 mm, which is slightly higher than before, but still relatively small. The maximum Mises equivalent stress rose to 240.7 MPa post-optimization, but brought about a uniform stress distribution at the bottom of the bracket. In comparison, the minimum factor of safety met design requirements at 1. The mass was lessened to 0.348 kg, representing a 49.2% decrease in comparison with pre-optimization levels. The 3D-printed bracket was fabricated by employing a 3D printer, thereby achieving the aforementioned mass abatement. The battery pack parts exhibited a bright surface with low roughness and no discernible warping or deformation defects. As revealed by the assembly results, the components of the battery pack bracket are tightly coordinated with each other, with no evident assembly conflicts, revealing that the dimensional accuracy and fit of the completed parts meet production requirements. These findings lay solid groundwork for the mass production of high-performance battery pack brackets.

Optimized Design of Canister Bracket

Optimized Design of Battery Bracket

Multi Load-Transmitting Device Based Support Layout Optimization for Large Fuselage Panels in Digital Assembly

Property Analysis and Structure Optimization of Robotic Arm Based on SolidWorks and ANSYS

Design and Optimization of Flexible Assembly Platform Used for Three Sections Joint

Design and Analysis of Battery Bracket Structures for Different Vehicles

Lightweight design of a steering power cylinder bracket

Optimizing Research on the Strengthen Bracket of Hull Lifting Lug

Design Forces of Horizontal Inter-Column Braces

Design optimization and application of hot-stamped B pillar with local patchwork blanks

Design Optimization of Upper Anchorage Structure for a Child Seat on Rear Floor (Continued 1)

Design and analysis on stamping process of car power battery fixed bracket based on CAE

Lifting-bracket Improvement Design Based on Topology Optimization

Topology Optimization of the Bracket Structure in the Acquisition, Pointing, and Tracking System Considering Displacement and Key Point Stress Constraints

Optimization Design of Torsion Beam Rear-Axle Assembly on a Particular Car

Durability Analysis and Optimization Design of Filler Cap

Optimization Design of Body Structure in Offset Crash

Topological Design of a Hinger Bracket Based on Additive Manufacturing

Optimization design of battery bracket for new energy vehicles based on 3D printing technology

CAE Optimization Analysis of Injection Process Parameters for the Moulding of Air Conditioner Bracket

Optimized Design of Lightweight Structure with Spare Wheel Fixed below Rear Floor