Abstract:Agile development is considered as an emerging trend in hardware design, and NoC-based multi-IP integrated system has become the mainstream solution. The most critical challenge of this solution is to design a common efficient NoC with ultra-high throughput and low-cost routers to meet the communication characteristics of varied applications. Usually, NoC can not achieve both the gains from high throughput and low cost because high-throughput router architectures need complex virtual channel control logic to ensure that the power consumption and area of buffers will not be too large. Meanwhile, the low-cost router architecture is difficult to achieve higher throughput by increasing the number of buffers due to its simple control circuits. Moreover, most routers in NoC are optimized only for specific applications. To address the problem, this paper presents a “viaduct theory” for throughput optimization and realizes a common NoC router architecture for different scenario requirements (CRAFT router). Firstly, we improve the top boundary of the router throughput with the fully-connected crossbar switch, which is an expensive solution for high throughput. Secondly, we use a method similar to the ring-decouple theory in low-cost routers to reduce the number of router buffers while maintaining high throughput. The experimental results show that the throughput for the low-cost program is 15.4% higher than the conventional router with the same overhead. For the high-performance program, our router saves 50% hardware overhead compared with fully-connected routers with the same throughput; The maximum throughput that can be achieved is 26.3% higher than conventional routers, and 14.2% higher than the other state-of-the-art designs.

Design of Access Converging Router with Large Capacity and High Performance Based IPv6

On the Design of Green Reconfigurable Router Toward Energy Efficient Internet.

A Cloud-ICT Convergence Service Architecture SDN/NFV Powered

A 320-Gb/S Ip Router With Qos Control

Designing Scalable Routers With A New Switching Architecture

Providing Personalized Converged Services Based on Flexible Network Reconfiguration.

A Reconfigurable Architecture For Implementation Of Network Traffic Control Function

Beamforming and Fronthaul Compression Design for Intelligent Reflecting Surface Aided Cloud Radio Access Networks

A Streams Based High Performance Ip/X.25 Router

Implementation of Scalable Routers with Direct Networks

CRAFT: Common Router Architecture for Throughput Optimization.

Analysis of A Scalable Switching Fabric for Internet Routers

Design and Implementation of A 320 Gb/S Switch Fabric

A Hybrid Router Combining Circuit Switching and Packet Switching with Virtual Channels for On-Chip Networks

Toward Power-Efficient Backbone Routers

Green Router: Power-Efficient Router Design

A Fast and High-Performance Global Router with Enhanced Congestion Control

1 2 A ug 2 01 9 Two Dimensional Router : Design and Implementation

Design and Implementation of Single-Buffered Routers

Power-proportional Router: Architectural Design and Experimental Evaluation

Analysis of Broadband IP Router Architecture