Abstract:This paper studied stagnation-induced changes of disinfectant and bacteria using an orthogonal test and kinetic analysis, and then proposed a disinfection strategy. Tap water from a drinking water distribution system and ultrafiltrated water were collected and disinfected with four disinfectants (concentrations were set 0.2-1 mg/L as Cl2. The study had several findings. First, disinfectants expanded lag phases and shortened generation times of the microbiome. Reduction in culturability, substrate responsiveness, respiratory activity, membrane potential and integrity subsequently occurred with increasing disinfection concentration. Second, the disinfectant decay rate decreased with initial disinfection concentration, and the effective disinfection phase (heterotrophic plate count (HPC) was less than 100 cfu/mL) was longer in water samples with lower organic matter. Moreover, the disinfection process was divided into an effective phase and an invalid phase (HPC>100 cfu/mL). Then a disinfection efficiency model was built and the regulation of disinfection by-products (DBPs) production was studied in chlorinated water samples, which provides a general method for other disinfectant studies. The average trihalomethanes (THMs) production during the effective phase (marked as THM/th) and THMs production during the invalid phase (marked as ΔTHM) were proposed to evaluate the DBPs production. The level of THM/th and ΔTHM were lower in ultrafiltrated water than those in tap water. THM/th were negatively correlated with initial chlorine concentration while ΔTHM were positively correlated with initial chlorine concentration. Finally, for the purpose of raising disinfection efficiency and decreasing DBPs, we propose periodic pulse disinfection.

Studies on the sequential chlorination disinfection technology

Simultaneous Control of Microorganisms and Disinfection By-products by Sequential Chlorination

Influence of Chlorination Conditions on Amount of Trihaloacetic Acids Formation

Desalinated Seawater into Pilot-Scale Drinking Water Distribution System: Chlorine Decay and Trihalomethanes Formation

Effect of Chlorination Conditions on Amount of THMs

Simultaneous control of microorganism, disinfection by-products and bio-stability by sequential chlorination disinfection]

Impact of UV Disinfection Combined with Chlorination on Bacterial Community Structure and the Formation of Trihalomethanes in Drinking Water

Control of Sanitary Indices by Sequential Disinfection Process

Synergetic Inactivation of Microorganisms in Drinking Water by Short-Term Free Chlorination and Subsequent Monochloramination.

[Optimal Process Combination for Control of Disinfection By-Products and Precursors].

An insight to sequential ozone‐chlorine process for synergistic disinfection on reclaimed water: Experimental and modelling studies

Performance and mechanism of sequential UV-NaClO disinfection: Inactivation and reactivation of antibiotic-resistant bacteria, disinfection byproduct formation and microbial community variation

Evaluation of sequential use of UV irradiation and chlorination to disinfect reclaimed water

Degradation Of Aqueous Polycyclic Musk Tonalide By Ultraviolet-Activated Free Chlorine

Control of Disinfection Byproducts in Safe-chlorine-disinfection Process

Use of two-points-short-term free chlorine plus chloramines disinfection process in conventional treatments of water supply

Coupling changes of disinfectant and bacteria induced by the water stagnation and disinfection strategy

Experiments with Different Combinations of Ultrafiltration Membrane Technological Processes for Biological Stability of Chlorine Disinfection in Drinking Water Treatment

[Disinfection By-Products Reduction of Combined Disinfection by Chlorine and Monochloramines in Distribution System].

Synergistic ferrate(VI) and chlorine for reclaimed water disinfection: Microbial control and chlorine decay mitigation