Abstract:The 10MW high temperature gas cooled test reactor (HTR-10) has been built in Institute of Nuclear and New Energy Technology (INET) and has been operating successfully since the beginning of 2003. The core outlet temperature of HTR-10 is 700°C. To verify the technology of gas-turbine direct cycle, at first INET had a plan to increase its core outlet temperature to 750°C and use a helium gas turbine instead of the steam generator (then the reactor is called HTR-10GT). Though HTR-10 has good intrinsic safety, the design basic accidents and beyond design basic accidents of HTR10-GT must be analyzed according to China's nuclear regulations due to changed operation parameters. THERMIX code system is used to study the ATWS accident of one control rod withdrawal out of the core by a mistake. After a control rod in the side reflector was withdrawn out at a speed of 1cm/s by a mistake, a positive reactivity was inserted and the reactor power increased and the temperature of the core increased. When the neutron flux of power measuring range exceeded 123% and the core outlet temperature was greater than 800°C, the reactor should scram. It was supposed that all the control rods in the reflectors had been blocked and the reactor could not scram. Thus the accident went on and the core temperature and the system pressure increased but the reactor shutdown at last because of its natural negative temperature reactivity feedback mechanism, in spite of the failure of bypass valve. The residual heat would be removed out of the core by the cavity cooling system. During the accident sequence the maximum fuel temperature was 1283.3°C. It was a litter than 1230°C – the fuel temperature limitation of HTR-10. Now the sphere fuel used in HTR-10GT will also be used in HTR-PM and the temperature limitation will be raised to 1620°C, so the HTR-10GT is safe during the ATWS of one control rod withdrawal out of the core. The paper also compares the analysis result of HTR10-GT to those of HTR-10. The results shows that the HTR-10GT is still safe during the accident though its operating temperature is higher than HTR-10. The analysis will be helpful to HTR-PM for they have the same outlet temperature of the core.

Analysis of Control Rod Reactivity Worths for Avr Power-Plant at Cold and Hot Conditions

Analysis of Boron Depletion in HTR Control Rod

Evaluation of the Control Rod Super Alloy Material of HTR-PM

A Comprehensive Study of the 14C Source Term in the 10 MW High-Temperature Gas-Cooled Reactor

ACTIVATION AND 3-DEMENSIONAL DOSE ANALYSIS SURROUNDING THE CONTROL RODS OF THE HTR-PM REACTOR WITH MONTE CARLO METHOD

The ATWS Analysis of One Control Rod Withdrawal out of the HTR-10GT Core

Optimization of Spatial Structure Designs of Control Rod Using Monte Carlo Code RMC

Calculation and Application of Discontinuity Factors in Control Rod Region for High Temperature Gas-Cooled Reactor

The ATWS analysis of one control rod withdraw out of the HTR-10GT core in addition with bypass valve failure

Quantification of Control Rod Worth Uncertainties Propagated from Nuclear Data Via a Hybrid High-Order Perturbation and Efficient Sampling Method

A new dynamic rod worth measurement method based on the transient spatial factor

NEUTRONIC AND THERMAL HYDRAULICS ANALYSIS OF CONTROL ROD EFFECT ON THE OPERATION SAFETY OF TRIGA 2000 REACTOR

PRELIMINARY DESIGN OF INTEGRAL-PLATE CRUCIFORM CONTROL ROD FOR NHR REACTOR

The effects of fuel type on control rod reactivity of pebble-bed reactor

Studies on the performance of the hydraulic control rod drive for the NHR-200

Source Term Analysis of the Irradiated Graphite in the Core of HTR-10

Design and Tests for the HTR-10 Control Rod System

An Method to Quantify Control Rod Worth Uncertainty Propagated from Nuclear Data

Equivalence of control rod model in high temperature gas-cooled reactor

Study on Control Rod Reactivity of Small Pebble Bed Reactor with Wallpaper Fuel Design

High Flux Reactor Review and Reactivity Control Analysis