Abstract:A damping strategy using a friction ring damper for an industrial flywheel was numerically and experimentally investigated. The friction ring damper, located on the arms of the flywheel, was experimentally found to effectively reduce the vibration amplitude of the flywheel. The vibration energy was dissipated when relative motions occur at the friction contact interfaces. Nonlinear dynamic analysis based on a lumped-parameter model of a flywheel equipped with a friction ring damper was conducted. The normal load, N, was used to evaluate the damping performance of the friction ring damper. For several values of N, steady-state responses under harmonic excitation and nonlinear modes were obtained using the harmonic balance method combined with the alternating frequency-time domain method. The forced response analysis proved the existence of an optimal value of N, which could minimize the vibration amplitude of the flywheel. The nonlinear modal analysis showed that all the damping ratio-frequency curves were completely coincident even for different values of N, and the frequency corresponding to the maximum damping ratio was equal to the frequency at the intersection of the forced response curves under the fully slip state and the fully stick state of the friction contact interface. By analyzing the behaviors of the friction contact interface, it was shown that the friction contact interface provides damping in the combined stick-slip state. The forced response under random excitation was calculated using the Runge-Kutta method, and the friction interface behaviors were analyzed. Finally, spectral testing was conducted to verify the numerical results.

Design of the Elastic Characteristics of Torsional Damper with Double Mass Flywheel and Circumferential Spring

Quantitative Analysis of Tubular Dual-Armature Switched Flux Permanent Magnet Machines for Shock Absorbers

Study on the Damping Characteristic of Semi-Active Torsional Damper Based on Combined Positive and Negative Stiffness

Analysis Method for Elastic Characteristics of Arc Spring

Dynamic Characteristics and Modeling of A New Magnetorheological Damper for Broadband Vibration Control

Research On Dynamic Characteristics Of A Magnetorheological Damper With Decoupling Mechanism

Research on Improved Magnetorheological Damper for Wide-Band Vibration Control

Design, Modeling, and Vibration Control of a Damper Based on Magnetorheological Fluid and Elastomer

Design and Modeling of a Novel Double-Piston Magnetorheological Damper

Design and experimental analysis of magneto-rheological damper featuring a labyrinthic dual-channel valve

Analysis and tests for a novel double-piston MR damper

Design method for spring accumulator of a single-ended MR Damper

Research on Nonlinear Vibration of Dual Mass Flywheel Considering Piecewise Linear Stiffness and Damping

Structural design and damping characteristics modeling of new recycling vibrational energy hydraulic vibration damper.

Vibration control with an inner-pass magnetorheological damper

Experimental and Theory Analysis on the Dynamic Characteristic of Flow-mode MRF Single-end Twin-tube Damper

Study on Vibration Attenuation Performance of A New Structural Electrorheological Fluid Damper

Numerical and Experimental Investigations on a Friction Ring Damper for a Flywheel

Design method of spring accumulator of single-ended MR dampers

Design and Study on the Dynamic-damper Mechanism for an In-wheel Motor Individual Drive Electric Vehicle

Design of a flexible dva in vibration transmission control of a flywheel at its flapping mode