Field Assessment of Lead Immobilization in A Contaminated Soil after Phosphate Application

R Melamed,XD Cao,M Chen,LQ Ma
DOI: https://doi.org/10.1016/s0048-9697(02)00469-2
2003-01-01
Abstract:A pilot-scale field demonstration was conducted at a Pb-contaminated site to assess the effectiveness of Pb immobilization using P amendments. The test site was contaminated by past battery recycling activities, with average soil Pb concentration of 1.16%. Phosphate amendments were applied at a 4.0 molar ratio of P/Pb with three treatments: T1, 100% P from H3PO4; T2, 50% from H3PO4+50% from Ca(H2PO4)2; and T3, 50% from H3PO4+5% phosphate rock. Soil samples were collected and characterized 220 days after P application. Surface soil pH was reduced from 6.45 to 5.05 in T1, to 5.22 in T2, and to 5.71 in T3. Phosphate treatments effectively transformed up to 60% of total soil Pb from the non-residual fraction (sum of water soluble and exchangeable, carbonate, Fe–Mn oxide, and organic fractions) to the residual fraction relative to the control. In addition, P treatments reduced Toxicity Characteristic Leaching Procedure (TCLP) Pb from 82 mg l−1 to below EPA's regulatory level of 5 mg l−1 in the surface soil. Scanning electron microscopy-energy dispersive X-ray elemental analysis and X-ray diffraction analysis indicated formation of insoluble chloropyromorphite [Pb5(PO4)3Cl] mineral in the P-treated soils. Although H3PO4 is necessary to dissolve meta-stable Pb in soil for further lead immobilization, it should be used with caution due to its potential secondary contamination. A mixture of H3PO4 and Ca(H2PO4)2 or phosphate rock was effective in immobilizing Pb with minimum adverse impacts associated with pH reduction.
What problem does this paper attempt to address?