Abstract:Application of poly-aluminum chloride (PACl) coagulant is a popular mode of water treatment worldwide because of the high capacity of PACl to neutralize charge. The manufacture and use of PACls with various basicities in different regions around the world suggest that the characteristics of the raw water are important determinants of the efficacy of PACl application. However, attention has not been fully paid to the effects of water quality other than the substances to be removed. In this study, two typical PACls with different basicities were used to investigate why the performance of PACls depends on the characteristics of the raw water. We focused on the concentrations of inorganic ions in the raw water. Use of high-basicity PACl (HB-PACl) with a high content of polymeric-colloidal species (Alb+Alc) resulted in very slow floc formation and little turbidity removal in raw water with low concentrations of sulfate ions. The performance of the HB-PACl was inferior to that of normal-basicity PACl (NB-PACl), although the charge-neutralization capacity of the HB-PACl was higher. Rates of floc formation were strongly correlated with the rate of aluminum precipitation by hydrolysis reaction, which was identified as an indicator for evaluating the compatibility of raw water with PACl treatment. Among the common ions in natural water, the sulfate ion had the greatest ability to hydrolyze and precipitate PACl because of its divalency and tetrahedral structure. This conclusion followed from experimental results showing similar effects for selenate and chromate ions as for sulfate ions and somewhat smaller effects for thiosulfate ions. Bicarbonate ions and natural organic matter affected PACl hydrolysis-precipitation, but chloride ions, nitrate ions, and cations had little effect on PACl hydrolysis-precipitation. Interestingly, the abilities of sulfate ions to hydrolyze HB-PACl and NB-PACl were very similar, but bicarbonate ions were less effective in hydrolyzing HB-PACl than NB-PACl, and bicarbonate ions contributed little to the hydrolysis-precipitation of HB-PACl in raw water with normal alkalinity. Therefore, sufficient coagulation with HB-PACl therefore usually requires a certain concentration of sulfate ions in water to be treated. The implication is that which anions are most influential to the hydrolysis-precipitation of PACl, and thus to PACl's coagulation ability depends on the constituents of the PACl.

Effect of citric acid on coagulation process with different coagulants

Novel ferromagnetic nanoparticle composited PACls and their coagulation characteristics.

Humic acid removal from water with polyaluminum coagulants: Effect of sulfate on aluminum polymerization

Alkalinity Effect of Coagulation with Polyaluminum Chlorides: Role of Electrostatic Patch

Coagulation performance and mechanism analysis of humic acid by using covalently bonded coagulants: effect of pH and matching mechanism of humic acid functional groups

Effect of aluminum speciation on arsenic removal during coagulation process

Coagulation Behaviour of Polyaluminium Chloride with Different Aluminium Speciation

Overlooked effect of ordinary inorganic ions on polyaluminum-chloride coagulation treatment

Influence of floc size and structure on membrane fouling in coagulation-ultrafiltration hybrid process--the role of Al13 species

[Coagulation performance and mechanism of Alb species in polyaluminum chloride in removing humic acid].

Relative Importance of Hydrolyzed Al(III) Species (ala, Alb, and Alc) During Coagulation with Polyaluminum Chloride: A Case Study with the Typical Micro-Polluted Source Waters

Effect of citric acid as a chelating agent on anodic behavior of pure iron with potentiostatic polarization and cyclic voltammetry methods

Coagulation Behavior of PAC with Different Aluminum Speciation Produced by Electrolysis Process

Coagulation effect of polyaluminum-titanium chloride coagulant and the effect of floc aging in fluoride removal: A mechanism analysis

Formation of Al30 aggregates and its correlation to the coagulation effect

Suitability of inorganic coagulants for algae-laden water treatment: Trade-off between algae removal and cell viability, aggregate properties and coagulant residue

Coagulation Behaviors of Aluminum Salts Towards Fluoride: Significance of Aluminum Speciation and Transformation

Effect of Pre-Coagulation Using Different Aluminium Species on Crystallization of Cake Layer and Membrane Fouling

Coagulation Behavior of Aluminum Salts in Eutrophic Water: Significance of Al13 Species and Ph Control

Effect of pH on the aluminum salts hydrolysis during coagulation process: formation and decomposition of polymeric aluminum species.

Coagulation and membrane fouling mechanism of Al species in removing humic acid: Effect of pH and a dynamics process analysis