Abstract:In general, only in tangential direction, friction motion between blade dampers is concerned for vibration analysis of mistuned bladed disk. However, in practical, excitation acting on blades inevitably causes normal movement at friction interface due to the existence of angle between excitation force and contact surface. This fact leads to a variation of normal force or even a result of contact separation, which determine the maximum static friction for tangential frictional vibration. In order to assess the realistic nonlinear forced vibration of mistuned disk assemblies subjected to actual excitation with nonlinear friction and contact, an efficient method is developed by using large-scale finite element model and two-dimensional friction model. In the proposed paper, attentions are paid on the realistic coupled vibration and the impact of variable normal vibration on forced response to a traveling wave excitation. Three types of mistuned parameters, including tangential stiffness of friction surface, initial shroud gap (corresponding to preload normal force), and structural stiffness of blades are taken into account for analyzing the effect of mistuning on the coupling vibration, especially for cases of contact separation. Furthermore, by means of curve fitting of amplitude variation of normal forces, the dependence of friction motion of bladed disk studied at circumferential resonance on variation of axial displacement, even with contact separation involved, is addressed. The results show a complex nonlinear vibration with friction and contact, especially a complex multiple unstable vibration observed with repeated nonlinear snap at circumferential resonance for the cases of contact separation. With regard to a small initial normal force, a large amplitude value of force variation can greatly reduce the maximum response amplitude for mistuned blades, which is worth to pay attentions for the vibration analysis of bladed disk with nonlinear friction and contact.

Nonlinear Performance of Decreasing Vibration by Friction on the Effect of Outside Vibration-exciting Force

Study on Fatigue Degradation Behavior of a Cracked Rotor Subjected to Lateral Vibration

Experimental and Numerical Study of Nonlinear Vibration in Compressor Stator Blade with Holding Ring Structure Considering Contact Friction

Noise Optimization of High-Speed Permanent Magnet Motor by Stiffeners

Coupled Bending and Torsional Vibration of a Rotor System with Nonlinear Friction

REDUCING VIBRATION WITH FRICTION-DAMPING IN HIGH-SPEED ROTOR SYSTEM

Dynamic Characteristics of a Rotating Blade with a Dovetail Fixture

The Dynamic Modeling and Numerical Simulation of Long Turbine Blades Group That Has the Dry Friction Damping Structure

Nonlinear Vibration Characteristics of a Flexible Blade with Friction Damping Due to Tip-Rub

Nonlinear Dynamics and Combination Resonance of a Flexible Turbine Blade with Contact and Friction of Shrouds

Study Of Snubbing Mechanism Using Finite Element Method

NUMERICAL MODEL AND OPTIMIZATION FOR DYNAMIC CHARACTERISTIC OF LONG BLADE WITH FRICTION DAMPER

NUMERICAL INVESTIGATIONS OF THE LONG BLADE PERFORMANCE USING RANS SOLUTION AND FEA METHOD COUPLED WITH ONE-WAY AND TWO-WAY FLUID-STRUCTURE INTERACTION MODELS

Theoretical and Experimental Investigations on Steady-State Responses of Rotor-Blade Systems with Varying Rotating Speeds Based on a New Nonlinear Dynamic Model

Nonlinear Vibration of Rotating Pre-Deformed Blade with Thermal Gradient

Dynamic response analysis of shrouded blades under impact-friction considering the influence of passive blade vibration

Analyses of the Single Blade Strength and Calculation of the Circle Blade Dynamic Frequency

Vibration Analysis of Mistuned Damped Blades with Nonlinear Friction and Contact

Dynamic Analysis And Optimization On Assembly Parameters Of Rod Fastening Rotor System With Manufacturing Tolerances

Influence of alternating loads on nonlinear vibration characteristics of cracked blade in rotor system

Non-linear dynamic analysis of a wind turbine blade