Abstract:A self-referencing technique compensating for fiber losses and source fluctuations in reflective air-gap intensity-based optical fiber sensors is described. A dielectric multilayer short-wave-pass filter is fabricated onto or attached to the output end face of the lead-in-lead-out multimode fiber. The incoming broadband light from a white light or a light-emitting diode is partially reflected at the filter. The transmitted light through the filter projects onto a mirror The light returning from the reflecting mirror is recoupled into the lead-in-lead-out fiber. These two reflections from the filter and the reflecting mirror are spectrally separated at the detector end. The power ratio of these two reflections is insensitive to source fluctuations and fiber-bending loss. However, because the second optical signal depends on the air-gap separation between the end face of the lead-in-lead-out fiber and the reflecting mirror, the ratio provides the information on the air-gap length. A resolution of 0.13 mu m has been obtained over a microdisplacement measurement range of 0-254 mu m. The sensor is shown to be insensitive to both fiber-bending losses and variations in source power. Based on this approach, a fiber-strain sensor was fabricated with a multilayer interference filter directly fabricated on the end face of the fiber. A resolution of 13.4 microstrain was obtained over a measurement range of 0-20,000 microstrain with a gauge length of 10 mm. The split-spectrum method is also incorporated into a diaphragm displacement-based pressure sensor with a demonstrated resolution of 450 Pa over a measurement range of 0-0.8 MPa. (C) 1996 Optical-Society of America

Self-Referenced Fiber Optic Sensor for Microdisplacement Measurement

Research of a Reflective Fiber-Optic Displacement Sensor with Intensity Compensation

Highly Sensitive Displacement Sensor Based on Composite Interference Established Within a Balloon-Shaped Bent Multimode Fiber Structure.

A Fiber-Based Chromatic Dispersion Probe for Simultaneous Measurement of Dual-Axis Absolute and Relative Displacement

Self-referenced Fiber Microbend Displacement Sensor Based on Dual-Wavelength Fiber-Bragg Gratings Interposed with a Multimode Fiber Micro Bender

A Bend Loss–based Singlemode Fiber Microdisplacement Sensor

Split-Spectrum Intensity-Based Optical Fiber Sensors For Measurement Of Microdisplacement, Strain, And Pressure

Fabry–Perot Interference-Based Fiber-Optic Sensor for Small Displacement Measurement

A Fiber-Based Chromatic Dispersion Probe for Simultaneous Measurement of X-Axis and Z-Axis Displacements with Nanometric Resolutions

Optical Fiber Micro-Displacement Sensor Using a Refractive Index Modulation Window Assisted Reflection Fiber Taper

High-precision micro-displacement optical-fiber sensor based on surface plasmon resonance.

A new application of optical fiber surface plasmon resonance for micro-displacement measurement

Experimental demonstration of a simple displacement sensor based on a bent single-mode–multimode–single-mode fiber structure

A Fiber-Optic Displacement Sensor Using the Spectral Demodulation Method

Design and Experimental Research on Miniature Fiber-Optic Displacement Sensor

A Macrobending Fiber Based Micro-Displacement Sensor

Wavelength Demodulation Method Using a Tilted FBG and a PSD for a Fiber Optic Micro-Displacement Sensor

A Micro-displacement Sensor Based on Cladding Mode Resonance of Optical Special Fiber

A Macrobending Fiber Based Micro-Displacement Sensor Utilizing Whispering-Gallery Modes

Fiber Bragg Grating Inscription in a Thin-Core Fiber for Displacement Measurement

High-Sensitive Microdisplacement Sensor Based on Fiber Mach–Zehnder Interferometer