Abstract:Adding lanes is a common method to increase the capacity at intersections. The additional turning lanes are often limited by the road configuration. The paper presents a probabilistic model to calculate the total capacity at signalized intersections for a full through lane and an additional left-turn lane. The proposed model has an advantage over current estimation methodologies by considering not only stochastic arrivals of vehicles but also the signal timing plan, especially signal phasing sequence. Two blockage situations under this channelization form arc taken into account. The proposed capacity model shows that the capacities of the through and left-turn movements are related to the proportion of the through traffic volume, the length of the additional turning lane, and the effective green time of both through and left-turn signal phases. It is also found that the through capacity increases with the increase of the proportion of the through traffic and the length of the additional lane, whereas the left-turn capacity declines with an increase of the proportion of the through traffic but increases with an increase of the length of the additional lane. Both capacities decrease with the increase of the green time when the g/C ratio is fixed. The proposed model is compared with design recommendations and verified using the microscopic traffic software VISSIM as well as field data. The results show that the capacities obtained by theoretical models are consistent with the simulated results, and have an advantage over the design recommendations. The capacity models can provide theoretical suggestions for the design of additional turning lanes and signal timing plans. (C) 2018 American Society of Civil Engineers.

Research on Calculation Method of Bicycle Capacity at Signalized Intersection

Influence of signal on the capacity of signalized intersection

Capacity of Bicycle Platoon Flow at Two-Phase Signalized Intersection: a Case Analysis of Xi'an City

Review on Calculation Method for Signalized Intersection Capacity

Capacity Calculating Methods for Signalized Intersections with One-way Traffic

Research on the bicycle capacity at signalized intersection based on fluid diffusion characteristics

A Bicycle Flow Diffusion Model at Signalized Intersections

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Research on the Optimal Method of Cycle Length for Signalized Intersection

Calculation method of travel time of right-turn vehicle at motor-and nonmotor-vehicle mixed traffic intersection

Study on Bicycle Crossing Capacity at Signalized Intersection

Bicycle Conversion Factor Calibration at Two-Phase Intersections in Mixed Traffic Flows

Capacities of Unsignalized Intersections under Mixed Vehicular and Nonmotorized Traffic Conditions

Bicycle and Pedestrians' Arrival and Departure Characteristics at Signalized Intersection

Bicycle Crossing Design and Signal Control Optimization for the Symmetric Intersection

Maximum cycle length optimization method of signalized intersection

Capacity Calculation Method of Urban Road Unsignalized T-intersections

Analysis on Relationships among Bicycle Traffic Capacity, Occupied Lane Width and Bicycle Traffic Demand at Intersection Areas

Study on calculation method for traffic capacity of three-phase intersection

Bicycle Traffic Flow Characteristics at Signaled Intersections Research

Methodologies for Determining the Capacity of Signalized Intersections in the National Standard in China