Abstract:OBJECTIVE:Based on establishment three-dimensional finite element models with the different defects of proximal femur, analysis of the local stress and strain changes under normal walking condition, speculate the probable rang of fracture and provide a theoretical basis for clinical work. METHODS:By CT scanning the whole femur, establish Three-dimensional finite element models were established with analogous to the loaded lower extremity under normal walking condition. The stress distribution of the zone of lesser trochanter, intertrochanter and femur neck were analyzed. RESULTS:(1) To the defects of lateral cortex of proximal femur at lesser trochanter level, defect of 5%-25%, the local maximum stress were up to 96.74-179.10 MPa. When the defect was greater than 10%, the local maximum was greater than the ultimate stress 141 MPa. While, the stresses of medial femur were 46.15-62.13 MPa, which was much lower than that of yielding stress. (2) At the level of intertrochanter with 5%-25% defect, the stresses were 45.70-127.11 MPa, all of them were lower than that of the ultimate stress. Whereas the changes of stress of medial femur were as the same as the stress at lesser trochanter level. (3) When the intramedullary defect of femur neck not involving inner cortex was less 40%, the local stress was lower than yielding stress 93 MPa. When the defects were 45% and 50%, the local maximum stress were up to 100.20 MPa and 119.40 MPa. (4) While intramedullary defects of femur neck involving half of medial cortex were 15%-50%, the stress were 87.79-1207.40 MPa. When the defects were above the level of 45%, the local maximum is greater than 141 MPa. CONCLUSION:The defects in lateral cortex of proximal femur has little influence on the medial cortex at the same level. And have little influence on the strength of femur; If defects located in the lateral cortex of lesser trochanter, 5% was relative safe, 5%-10% was at the risk of fracture, and defects larger than 10% would result in fracture. When defects located in the lateral femur at the level of intertrochanter area, 20% was relative safe, but defects larger than 25% would have the risk of fracture. If intramedullary defects in femur neck was smaller than 45% and not involved inner cortex, it was believed safe. When intramedullary defects in femur neck involved half of cortex, it was relatively safe below 20%, 20%-40% was at the risk of fracture, and larger than 40% resulted in fracture.

[Finite Element Analysis (FEA) for the Structure Capacity of Proximal Femur During Falling--(i) FEA Model and the Failure Criteria for the Bone].

[Finite Element Analysis (FEA) for the Structure Capacity of Proximal Femur During Falling--(ii). the Effects of Falling Configuration and Load Locations on the Structural Capacity of the Proximal Femur].

3D Finite Element Analysis of a Man Hip Joint Femur under Impact Loads

Effects of Impact Speeds, Fall Postures and Cortical Thicknesses on Femur Fracture by Incremental Element Deletion Based Finite Element Analysis

Incremental Element Deletion-Based Finite Element Analysis of the Effects of Impact Speeds, Fall Postures, and Cortical Thicknesses on Femur Fracture

Fracture prediction for the proximal femur using finite element models: Part I--Linear analysis

Structural Collapse Analysis Based on Finite Particle Methodⅱ： Key Problems and Numerical Examples

[Finite element analysis on fracture relevance as bone defect of proximal femur].

Finite element analysis of biomechanics of intact femur in normal human standing model

Fracture prediction for the proximal femur using finite element models: Part II--Nonlinear analysis

The Effect of Bone Loss Pattern on the Structural Capacity of the Proximal Femur

Finite Element Analysis of Impact Loads on the Femur.

Femoral fracture load and damage localisation pattern prediction based on a quasi-brittle law : linear and non-linear FE meshing

Finite Element Analysis of Mice Tibia under Impact Loading

How accurately do finite element models predict the fall impact response of ex vivo specimens augmented by prophylactic intramedullary nailing?

Three-dimensional finite element analysis of biomechanical properties of proximal femoral structure under the normal standing position

PREDICTION OF PROXIMAL FEMORAL FRACTURE IN SIDEWAYS FALLS USING NONLINEAR DYNAMIC FINITE ELEMENT ANALYSIS

On Fatigue Failure Prediction of Prosthetic Devices Through XFEM Analysis

In-Vivo Assessment of Femoral Bone Strength Using Finite Element Analysis (FEA) Based on Routine MDCT Imaging: A Preliminary Study on Patients with Vertebral Fractures

A Comparative Study on the Multiscale Mechanical Responses of Human Femoral Neck Between the Young and the Elderly Using Finite Element Method

Finite element analysis of hip fracture risk in elderly female: The effects of soft tissue shape, fall direction, and interventions