Abstract:This study is aimed at providing an effective method for determining strain-load relationship and at quantifying the strain distribution within the whole tibia under axial compressive load on rats. Rat tibial models with axial compressive load were designed. Strains in three directions (0°, 45°, and 90°) at the proximal shaft of the tibia were measured by using a strain gauge rosette, which was used to calculate the maximum and minimum principal strains. Moreover, the strain at the midshaft of the tibia was measured by a single-element strain gauge. The slopes of the strain-load curves with different peak loads were calculated to assess the stability of the strain gauge measurement. Mechanical environment in the whole tibia by the axial compressive load was quantified using finite element analysis (FEA) based on microcomputed tomography images. The von Mises elastic strain distributions of the whole tibiae were evaluated. Slopes of the strain-load curves showed no significant differences among different peak loads (ANOVA; P > 0.05), indicating that the strain-load relationship obtained from the strain gauge measurement was reasonable and stable. The FEA results corresponded to the experimental results with an error smaller than 15% (paired Student's t-test, P > 0.05), signifying that the FEA can simulate the experiment reasonably. FEA results showed that the von Mises elastic strain was the lowest in the middle and gradually increased to both sides along the lateral direction, with the maximal von Mises elastic strain being observed on the posterior side under the distal tibiofibular synostosis. The method of strain gauge measurements and FEA used in this study can provide a feasible way to obtain the mechanical environment of the tibiae under axial compressive load on the rats and serve as a reference for further exploring the mechanical response of the bone by axial compressive load.

Finite Element Analysis of Mice Tibia under Impact Loading

3D Finite Element Analysis of a Man Hip Joint Femur under Impact Loads

Finite Element Analysis of Impact Loads on the Femur.

Effects of Impact Speeds, Fall Postures and Cortical Thicknesses on Femur Fracture by Incremental Element Deletion Based Finite Element Analysis

Incremental Element Deletion-Based Finite Element Analysis of the Effects of Impact Speeds, Fall Postures, and Cortical Thicknesses on Femur Fracture

Finite Element Modeling and Injury Criteria Investigation for the Lower Leg of the Chinese Human Body under Impact Loads

A Finite Element Analysis Study Based on Valgus Impacted Femoral Neck Fracture under Diverse Stances

Finite element analysis of biomechanics of intact femur in normal human standing model

Three-dimensional dynamic finite element analysis of the patterns of calcaneal fractures

Computational evaluation of foot biomechanical response to low energy Lisfranc ligament injury

[Biomechanical Research on Upper Femur with Vertical and Bending Stress].

Study on the Long Bone Failure Behaviors under the Indenter Rigid-Contact by Experiment Analysis and Subject-Specific Simulation

Finite Element Analysis of Foot and Ankle Impact Injury: Risk Evaluation of Calcaneus and Talus Fracture

Research of Biomechanics of Rabbit's Tibia During Stress Fracture

[Finite Element Analysis (FEA) for the Structure Capacity of Proximal Femur During Falling--(i) FEA Model and the Failure Criteria for the Bone].

[Simulation of the Rat Tibial Bone Density Changes with the Finite Element Method].

Study on the Numerical Simulation of Femoral Injury

Prediction of Long Bone Fractures via Reconstruction of Pedestrian Accidents Using Multi-Body System and FE Models

Research on Finite Element Analysis to Evaluate the Femoral Mechanical Properties of Tail-suspended Rats

Strain Distribution Evaluation of Rat Tibia under Axial Compressive Load by Combining Strain Gauge Measurement and Finite Element Analysis.

Fracture prediction for the proximal femur using finite element models: Part I--Linear analysis