Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Simulation on the Smoke Transport Process to Remote Room During a Residential Building Fire Based on FDS

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Simulation of Fire Smoke Spread in a Super High-Rise Building for Different Fire Scenarios

Simulation of Fire Smoke and Evacuation Control in Underground Commercial District of Large Commercial Complex

Evaluation of Smoke Harm and Fatalness in High-Rise Building Fire

Large Eddy Simulation of Smoke Movement in a Teaching Building

Numerical Simulation for Fire Smoke Flow in a Tall Building with Multi-Story Hollow Space

Simulation Study on Air Curtain and Smoke Exhaust System of Long Corridor High-rise Building with Regional Ecological Environment Characteristics

Risk analysis research of fire smoke in the corridor of an university teaching building

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Computer Simulation of the Smoke Movement Pattern in Large Building Fire

Building Fire Smoke Control Strategies Simulation Using Fire and Evacuation Information

Application of CFAST Software in High-rise Student Apartment Fire Area Simulation

Simulation on the movement of smoke in a compartment

Indoor Fire Simulation in Low-Rise Teaching Buildings Based on BIM–FDS

Three-dimensional Large Eddy Simulation of Smoke Flow during Indoor Fire

Experimental and Numerical Study on the Smoke Movement and Smoke Control Strategy in a Hub Station Fire

Numerical Simulation for Fire Smoke Flow in a High-rise Building with Patio Space

Numerical Simulation of Smoke Control in Underground Bus Station

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

A Performance-Based Design on Smoke Prevention and Extraction in a Large Space Primary Processing Workshop of Cigarette