Abstract:The tension and compression deformation behavior of extruded magnesium-1 wt pct manganese alloys with nominally 0.3 wt pct (MN10) and 1 wt pct neodymium (MN11) was studied over the temperature range of 298 K to 523 K (25 °C to 250 °C). Nd additions to Mg alloys tend to reduce the strong basal texture exhibited by conventional wrought Mg alloys and this work was intended to study the effect of Nd on the deformation behavior of Mg alloys. In situ tensile and compressive experiments were performed using a scanning electron microscopy, and electron backscatter diffraction was performed both before and after the deformation. A slip trace analysis technique was used to identify the distribution of the deformation systems as a function of strain, and based on this analysis and the texture of the undeformed samples, the critical resolved shear stress ratios between the deformation systems were estimated. In the case of MN11, the deformation behavior under tension at all temperatures was dominated by slip, while in compression, extension twinning was the major deformation mode. In tension at 323 K (50 °C), extension twinning, basal, prismatic 〈 a 〉, and pyramidal 〈 c + a 〉 slip were active in MN11. Much less extension twinning was observed at 423 K (150 °C), while basal slip and prismatic 〈 a 〉 slip were dominant and presented similar relative activities. At 523 K (250 °C), twinning was not observed, and basal slip controlled the deformation. With the reduction of Nd content, less slip deformation and more twinning were observed during the tensile deformation. However, like for MN11, the extent of twinning in MN10 decreased with increasing temperature and basal slip was the primary deformation mode at elevated temperatures. Extension twinning was the major deformation mode under compression for all test temperatures in MN10 and MN11. The tensile strength decreased with increasing temperature for both alloys, where MN10 was slightly stronger than MN11 at 323 K (50 °C), which was expected to be a result of the stronger basal texture exhibited by MN10 due to its lower Nd content. However, MN11 maintained its strength more at elevated temperatures compared with MN10, and this was explained to be a result of the greater Nd content.

Study on elevated temperature mechanical properties of AM50HP with Nd

Influence of Nd on the mechanical properties and high temperature creep properties of AM50 magnesium alloy

Effects of Nd on microstructures and properties at the elevated temperature of a Mg–0.3Zn–0.32Zr alloy

Effects of Nd on Microstructure Mechanical Properties of Mg-10Gd-3Y-0.5Zr Alloy

Effect of Alloying with Al, Nd and Ca and Heat Treatment on Microstructures and Mechanical Properties of Vacuum Die-Cast AM50 Alloy

Effects of Nd on mechanical properties of magnesium alloy AZ91

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Effect of Nd on Microstructures and Properties of AZ31 Wrought Mg Alloy

Effects of Nd on the Microstructure and Mechanical Property of Za52 Alloy

Effect of Nd on Microstructure and Mechanical Properties of Mg-13Gd-0.5Zr Alloy

Microstructure and Mechanical Properties of Mg–4.5Zn–xNd (x=0, 1 and 2, Wt%) Alloys

Effect of Nd on the Microstructure and Mechanical Properties of Hot Extruded Mg-2.0Sm-0.4Zn-0.4Zr Alloy

Effects of Y and Nd combined addition on mechanical properties of Mg-6Al alloy

Microstructures and Mechanical Properties of As-Cast Mg–5Al–0.4Mn–xNd (x = 0, 1, 2 and 4) Alloys

The Effect of Nd on the Tension and Compression Deformation Behavior of Extruded Mg-1Mn (wt pct) at Temperatures Between 298 K and 523 K (25 °C and 250 °C)

Effects of Nd on Microstructure and Mechanical Properties of Cast Al-Si-Cu-Ni-Mg Piston Alloys

Effects of Nd on the microstructure of ZA52 alloy

Achieving superior elevated-temperature strength of Mg-12Gd-3Y alloys by Nd addition

Effect of Nd Content and Heat Treatment on the Thermal Conductivity of Mg Nd Alloys

Effect of rare earth Nd on the microstructural transformation and mechanical properties of 7xxx series aluminum alloys

Microstructure and Mechanical Properties at Elevated Temperature of Mg-Al-Ni Alloys Prepared Through Powder Metallurgy