Precise Laser Seam Welding of Ultra Thin Stainless Steel Sheet

黄冬林,杨永强

DOI: https://doi.org/10.3969/j.issn.1002-025x.2009.08.009

2009-01-01

Abstract:Nd:YAG laser was used to welding the 304 ultra-thin stainless steel sheet through seam welding at speed of 1.5 mm per second. The influence of process parameters such as laser pulse power,pulse width,pulse frequency and defocus amount on weld shaping of the steel was studied. In addition,the changes of the laser pulse width and pulse frequency to affect the weld width were investigated. The experimental results showed that the weld of 304 stainless steel of ultra-thin 0.15 mm was smooth and beautiful by precise laser seam welding when the current was 78 A,the pulse frequency was 10 Hz,the pulse width was 1 ms,and the defocus amount was +2 mm. As the current and pulse width increased,the weld width increased,and welding splash occured. Finally,the sample was oxidized and burned. As the pulse frequency increased,the overlapping rate of weld spot and weld width increased,the surface of weld beam was increasingly smooth,but rear surface of the sample was oxidized. The results indicated that the positive defocus amount was more easier to get smooth and beautiful weld than the negative defocus amount when the material was ultra-thin sheet.