Fabrication of Nitrogen and Sulfur Codoped Titanium Dioxide and Its Visible Light Photocatalytic Activity

BAI Yu-na,ZUO Sheng-li,YU Ying-chun,LIU Jian-jun,LI Bao-shan
DOI: https://doi.org/10.3969/j.issn.1008-1011.2013.04.006
2013-01-01
Abstract:A series of visible light photocatalysts of TiO 2 codoped with N and S (denoted as NS/TiO2 ) were prepared by facile grinding-calcination method with thiourea (TU ) as the source of sulfur and nitrogen and H 2 TiO3 (HT ) as the precursor of TiO2 .The crystal structure ,micro-morphology ,chemical state of typical elements ,and spectrometric properties of as-prepared NS/TiO2 photocatalysts were analyzed by means of X-ray diffraction ,transmission electron mi-croscopy ,X-ray photoelectron spectroscopy ,Raman spectrometry ,and ultraviolet-visible light absorption spectrometry .The specific surface area of as-prepared NS/TiO2 photocatalysts was determined by BET method ,and their catalytic activity towards the degradation of Rhodamine B under visible light irradiation was evaluated .Results show that as-prepared NS/TiO2 photo-catalyst with a TU to HT mass ratio of 0 .5∶1 exhibits the highest photocatalytic activity and provides a Rhodamine B degradation rate of 44 .4% after 70 min of irradiation .Besides ,N in the form of NH3 is adsorbed on the surface of TiO2 ,and S exists in the form of S6+ and partially substitutes Ti 4+ in TiO2 lattice .In the meantime ,N and S codoping contributes to reduce the prohibited bandgap of TiO 2 thereby increasing its photocatalytic activity .
What problem does this paper attempt to address?