Effects of the stoichiometric ratio of aluminium and manganese on electrochemical properties of hydrogen storage alloys

M.-S. Wu,H.-R. Wu,Y.-Y. Wang,C.-C. Wan
DOI: https://doi.org/10.1023/A:1024910715770
IF: 2.925
2003-01-01
Journal of Applied Electrochemistry
Abstract:With the aim of enhancing the capacity and electrochemical performances of hydrogen-storage alloy electrodes, MmM 4.3 (Al 0.3 Mn 0.4 ) x (Mm = La-rich mischmetal, M = Ni, Co) alloys were investigated. MmM 4.3 (Al 0.3 Mn 0.4 ) x alloys possessing appropriate plateau pressure and high storage capacity can be obtained by adjusting the stoichiometric ratio of Al–Mn ( x value). In this situation, the unit cell volumes increase with increasing x and the enthalpy changes of hydride formation decrease with increasing x , thereby changing the alloy properties in the gas phase and the electrochemical environment. The plateau pressure and the charge potential both increase with decreasing x . The x value influences the surface states and bulk properties. When x is lower than 0.5, both the charge-transfer reaction on the alloy surface and the diffusion resistance within the bulk alloy are much improved. High-rate dischargeability at high current density is controlled mainly by the limiting current density. MmM 4.3 (Al 0.3 Mn 0.4 ) 0.5 alloy, having the highest storage capacity and good electrochemical performance, is an appropriate candidate for battery materials.
What problem does this paper attempt to address?