Abstract:Epoxy-based photosensitive polymers with two different cinnamoyl side groups (cinnamoyl group and 4-octyloxy cinnamoyl group) were prepared by functionalization of the polymer precursor ( BP-AN). Two kinds of photo-sensitive molecules including cinnamoyl groups were also prepared: hydroquinone dicinnamate obtained by reaction between hydroquinone and cinnamoyl chloride, while hydroquinone di (4-octyloxyl) cinnamate synthesized through reaction between hydroquinone and 4-octyloxy cinnamoyl chloride. All chemicals were characterized by necessary spectroscopic methods including H-1-NMR and FTIR, which indicated their accurate molecular structures had matched our target molecules.The photo-sensitive molecules were doped into corresponding photo-sensitive polymers in different proportions respectively, and photo-alignment layers were prepared based on the spin-coated films of the polymers, which were irradiated under LPUV (linearly polarized ultra violet) and then used to assemble LC cells filled with nematic liquid crystal 5CB. The photo-alignment behavior of the doped polymers was characterized by the microscopic observation and comparing the numerical value of T-max /T-min in sinusoid-curves of LC cells.The results showed that, below a certain doping point (about 10%), increasing the concentration of the photosensitive molecules would result in a better photo-alignment performance. Since the photo-dimerization reaction of cinnamoyl groups happens only when two cinnamoyl groups stand in properly spatial positions to form a tetra-atomic ring. Doped molecules greatly added up the amount of cinnamoyl pairs with adequate steric relations, thus created greater chance for cinnamoyl groups to crosslink and improved the LC-alignment performance. By doping different amount of photo-sensitive molecules we found the ideal doping point would be around 10% ( n(p) : n(m)). Doping content going up higher than that would lead to a worse alignment effect, with the presence of irregular patterns and luminous points under light microscope, and decreased contrast too. Luminous points were probably caused by the limited compatibility between the polymer and the doped molecules, and doped photo-sensitive molecules cumulated and became crystallized. As for irregular patterns, they are surely caused by the weak photo-alignment ability of the doped polymer. On one hand, tiny crystals would disturb the uniformity of the surface; on the other hand, it is possible that the existence of excess amount of cinnamoyl groups would both enhance photo-dimerization and photo-isomerization reactions. which are competitive reactions and lead to opposite alignment directions: photo-dimerization would align the LC molecules parallel to the polarization direction of LPUV, while photo-isomerization would align them perpendicular to the polarization direction of LPUV.At the same time,we found that LC cells doped with 4-octyloxy cinnamoyl groups showed a higher increase in photo-alignment performance, which indicated that the effect of doping varied for different systems,and this method could be rather useful for certain polymers.In a word, we' ve synthesized two novel photo-sensitive molecules and doped them into epoxy polymers to enhance the alignment ability of the material with success. In our case, the contrast could be doubled or even tripled by doping adequate amount of photo-sensitive molecules. The optimum doping amount found is around 10%, regardless of the assortments of epoxy polymers.

Addition of Functional Characteristics of Organic Photochromic Dye to Nano-Structures by Selective Doping on a Polymer Surface

Molecular doping of photochromic dye into polymer substrates by the “vapor transportation method” and their photochromic behavior

Doping of Photochromic Dye to Polymer Substrates by Vaporization of the Dye in a Vacuum

Photo-Induced Charge Generation of TiO<sub>2</sub> Nanotube Modified with Polymer Containing C<sub>60</sub> under Irradiation of Visible Light and its Applications

Electron Donor and Acceptor Functionalized Dithienylethenes: Effects of Charge Density on Photochromic Properties

Enhanced Photochromism of Heteropolyacid/Polyvinylpyrolidone Composite Film by Tio2 Doping

Photoimageable Organic Coating Bearing Cyclic Dithiocarbonate for a Multifunctional Surface

Enhanced Electrochromic Properties of Donor–acceptor Polymers Via TiO2 Composite

A Diarylethene-Based Photoswitch and Its Photomodulation of the Fluorescence of Conjugated Polymers

Photochromic characteristic of cationic photoinitiator and fluorane dye system microencapsulated in sub-micrometre scale

A Photoswitchable and Thermally Stable Axially Chiral Dithienylperfluorocyclopentene Dopant with High Helical Twisting Power

A Photochromic Naphthopyran Dye Activated by the Intramolecular Hydrogen Bond and Its Photodynamics in the Ormosil Matrix Coating

Photoresponsive Electrospun Polycaprolactone Nanofibrous Structure Embedding Dithienylethene Molecules

Preparation and Photochromic Behavior of Novel Hybrid Inorganic-Organic Thin Film

Photochromic and photo-regulated fluorescent coordination polymers derived from thiazolothiazole extended viologen in solid state and polymer film

Sonochemical preparation of photochromic nanocomposite thin film based on polyoxometalates well dispersed in polyacrylamide

Synthesis of novel photochromic dithienylethenes and investigation on their optoelectronic properties

THE EFFECT OF DOPING PHOTO-SENSITIVE MOLECULES ON THE PROPERTIES OF EPOXY-RESIN BASED PHOTO-ALIGNMENT MATERIALS

Photoinduced Morphology Change in Ionic Supramolecular Block Copolymer

Tuned Intra‐ and Intermolecular Photoreactions of Tridentate Cyanostilbenes with Distinct Aggregated‐State Photomechanical and Dispersed‐State Photochromic Behaviors

Photochromic Properties of -Cyclodextrin Dimer Linked by Dithienylethene