Abstract:In this study, cooling of a plastic pipe-end during a hot-forming process that is one of the commonly used forming methods in plastic pipe production to get seal housing place (muff) was investigated numerically and experimentally. The aim of this study was development of a cooling die that has higher cooling performance and easier manufacturability. Cooling is supplied by the circulation of conditioned water in the channels located in the die in plastic production. The geometry of these channels and mass flow rate and temperature of the cooling water are the parameters affecting the quality of the formed region and process time. In the study, experimental analyses were performed, then numerical analyses were realised and validated with the experimental results for the existing die geometry. Continuity, momentum and energy equations were solved all together and heat transfer was investigated. After validating the model, a few different alternative die models were proposed and analysed to get an optimum which has highest cooling capacity and process ability. At the end of these studies, optimum alternative die geometry was determined. The channels in the suggested die were developed to increase the homogeneity of the cooling by changing the existing channel’s shape which can be produced by only longitudinal holes. A simple production method was also suggested for the new die to locate the channels following the circumference of the pipe, like conformal cooling channels. Additionally, aluminium material was also used to decrease the pipe temperature and die weight in the analyses. In conclusion, although cooling process time and mean temperature of the pipe-end were 30 secs and 43.9 o C respectively for the existing cooling die, these values were determined as 30 secs and 39.5 o C for the optimised aluminium die. If the temperature of the cooled pipe is taken as the same with the existing cooling, the cooling time decreases to around 20 secs for the suggested die. The weight of the die was reduced from 86.57 kg to 16.22 kg.

Numerical Simulation of the Cooling Process of Extruded Plastic Profiles Within Vacuum Calibrators

Optimization design in cooling channels of vacuum calibrator for plastic profile extrusion

Numerical Simulation on the Cooling Stage for Injection Molded Parts of Crystalline Plastics

Review of Numerical Simulation on Cooling Process of Injection Moulds

Numerical Study of Heat Transfer and Temperature in the Screw Groove for Molten Plastic

Numerical Analyses of Deformation Mechanisms in a Novel Dimensional Calibration Technique for Thin-Walled, Open Extrusions

Research on the CAE Technology and Optimization Design Method of Extrusion Dies for Plastic Profiles

Numerical simulation of temperature history during the picture tube panel-forming process

Numerical Simulation of the Temperature Field in Kinescope Glass Shell Forming Process

Parametric Study of Temperature Field During the Cooling Stage for Extrusion Blow Molded Part

Numerical Simulation of Injection Molding Cooling Process Based on 3D Surface Model

Coupled thermo-mechanical analysis for plastic thermoforming

CAE of Mold Cooling in Injection Molding Using a Three-Dimensional Numerical Simulation

The Study of Thermal Process and Temperature Calibration for a Vacuum Drying Oven Based on Numerical Simulation

Three-dimensional transient finite element cooling simulation for injection molding tools

Numerical Simulation of Heat Transfer Process of Plastic Film Prepared through Casting Method

Optimization Of The Flow Distribution In Extrusion Die Of Plastic Profile

Part cooling in blow molding: Finite element simulation

Numerical simulation and mold structure optimization of extrusion for radiator profile with high-density fins

Numeric Al Simulation and Optimization of Cooling System for 2 M Accelerating Tube

DEVELOPMENT OF A COOLING DIE USED IN PLASTIC PIPE PROCESSING: NUMERICAL AND EXPERIMENTAL ANALYSIS